Electrolux 60820 manual Electronic adjustment

Page 12

Operating Instructions

Adjust the water softener to the hardness of the water in your area as stated in the table:

0 1. The dishwasher must be switched off.

2. Manual adjustment: Open the dishwasher door.

3. Remove the lower rack from the dishwasher.

4.Turn the water hardness switch to 0

or 1.

5. Re-position the lower rack.

6. Electronic adjustment:

Simultaneously press and hold down function buttons 1 and 2.

7.Press the ON/OFF button.

The LED displays for the engaged function buttons will flash.

8.Press function button 2 again.

The multi-display will show which hardness setting has been set.

9.Pressing function button 2 increases the hardness setting by 1. (Exception: hardness setting 0 follows hardness setting 9).

10.Once the hardness setting is set correctly, press the ON/OFF switch. The hardness setting is then saved.

Image 12

Contents Favorit Tips on using the appliance Dear customerPlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions What to do, ifSafety Instructions Installation, Connection and Placing into OperationChild Safety General SafetyCorrect Use Disposal Economical and Ecological DishwashingDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Control Panel Multi-Display can displayPrior to using for the first time Adjusting the Water Softener Special saltYour area Electronic adjustment Filling with Salt for the Water Softener Fill with dishwasher saltUse dishwasher salt Open the door, remove the lower Rack Turning it anticlockwiseSwitching Rinse Aid Supply On and Off Rinse AidThere are two ways to add rinse aid Filling with Rinse Aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Tioned horizontally in the upper basketPlace knives, small spoons and small Forks in the cutlery trayLoading Pans, Frying Pans Large Plates Loading Cups, Glasses and Coffee Services Fold the plate insert to the leftAdjusting the Height of the Upper Basket Lowering the Upper BasketRaising the Upper Basket Filling with Detergent Fill with detergentConcentrated Detergent Detergent tabletsAutomatic Wash Programmes Selecting the Wash Programme Programme Table SoilingChanging/Interrupting/Cancelling Start the Wash ProgrammeWash Programme Changing the wash programmeSetting or Changing the Delay Start Timer Cancelling the wash programmeDishwasher is switched on again Changing the delay startSwitching Off the Dishwasher Load Sensing Sensor LogicEmptying the Dishwasher Immediately after the end of the programmeCare and Cleaning Cleaning the FilterWhat to do, if StancesError messages Symptom Possible Cause SolutionThere are problems with the operation of the dish- washer Wash results are not satisfactoryDishes are still dirty Wrong wash programme was selectedTechnical Data Dishes are wet and dullRinse aid was not used Rinse aid container is empty Lower rinse aid dosingSample loading arrangements Upper basket without cutlery trayLower basket with cutlery basket Installing the Dishwasher See enclosed installation instructionsBuilt-Under Dishwasher Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedConnecting the Dishwasher Water ConnectionPermitted water pressure Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions 08705 929 Customer CareCalls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG