Electrolux 60820 manual Leak Prevention System, Appliance is automatically pumped out

Page 39

Installation and Connection Instructions

	Leak Prevention System
	For protection from damage due to water leaks, the dishwasher is
	equipped with a leak prevention system, the AQUA CONTROL SYSTEM.
	In the event of a fault, the safety valve immediately interrupts the sup-
	ply of water to the appliance and the drain pump switches on. By this
	means water can neither escape nor overflow. The remaining water in
	the appliance is automatically pumped out.
1	The AQUA CONTROL SYSTEM also works when the appliance is switched
	off – the appliance must however not be disconnected from the mains.

Image 39

Contents Favorit Pass them on to any subsequent owner of the appliance Tips on using the applianceDear customer Please read these user instructions carefullyContents What to do, if Installation and Connection InstructionsGeneral Safety Safety InstructionsInstallation, Connection and Placing into Operation Child SafetyCorrect Use Disposal of Old Appliances DisposalEconomical and Ecological Dishwashing Disposing of the Packaging MaterialAppliance Features and Control Panel Multi-Display can display Control PanelPrior to using for the first time Adjusting the Water Softener Special saltYour area Electronic adjustment Turning it anticlockwise Filling with Salt for the Water SoftenerFill with dishwasher salt Use dishwasher salt Open the door, remove the lower RackSwitching Rinse Aid Supply On and Off Rinse AidThere are two ways to add rinse aid Fully open the rinse aid compartment lid Filling with Rinse AidDaily Use Adjusting Rinse Aid DosingNot be washed in the dishwasher Loading Cutlery and DishesForks in the cutlery tray Loading CutleryTioned horizontally in the upper basket Place knives, small spoons and smallLoading Pans, Frying Pans Large Plates Fold the plate insert to the left Loading Cups, Glasses and Coffee ServicesAdjusting the Height of the Upper Basket Lowering the Upper BasketRaising the Upper Basket Fill with detergent Filling with DetergentConcentrated Detergent Detergent tabletsAutomatic Wash Programmes Soiling Selecting the Wash Programme Programme TableChanging the wash programme Changing/Interrupting/CancellingStart the Wash Programme Wash ProgrammeChanging the delay start Setting or Changing the Delay Start TimerCancelling the wash programme Dishwasher is switched on againImmediately after the end of the programme Switching Off the DishwasherLoad Sensing Sensor Logic Emptying the DishwasherCleaning the Filter Care and CleaningStances What to do, ifSymptom Possible Cause Solution Error messagesWrong wash programme was selected There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are still dirtyLower rinse aid dosing Technical DataDishes are wet and dull Rinse aid was not used Rinse aid container is emptySample loading arrangements Upper basket without cutlery trayLower basket with cutlery basket Free-Standing Appliances Installing the DishwasherSee enclosed installation instructions Built-Under DishwasherWork surface must be re-mounted Plinth on free-standing appliances is not adjustableConnect the inlet hose Connecting the DishwasherWater Connection Permitted water pressurePlease take care when installing the water inlet hose Water inlet hose with safety valveWater drain Appliance is automatically pumped out Leak Prevention SystemChanging a fuse Electrical ConnectionConnections Guarantee Conditions 08705 929 Customer CareCalls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG

Leak Prevention System

the appliance is automatically pumped out.