Electrolux 60820 manual Daily Use, Adjusting Rinse Aid Dosing

Page 16

Operating Instructions

	Adjusting Rinse Aid Dosing
3	As the dishes are washed rinse aid is released from the dispenser into
	the wash water. The dose is factory set at 4, and can be adjusted from

1 to 6. Only change the setting if streaks, milky spots or dried on water marks are visible on glasses or crockery.

0 1. Open the door of the dishwasher.

2.Press the rinse aid compartment release button with your finger.

3. Fully open the rinse aid compartment lid.

4. Set the dose level.

5. Close the lid and press until it locks into place.

6.If rinse aid has run out, wipe up with a cloth.

In Daily Use

•Check the salt and rinse aid levels.

•Load cutlery and dishes into the dishwasher

•Fill with dishwasher detergent

•Select a wash programme suitable for the cutlery and dishes

•Start the wash programme

Image 16

Contents Favorit Tips on using the appliance Dear customerPlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions What to do, ifSafety Instructions Installation, Connection and Placing into OperationChild Safety General SafetyCorrect Use Disposal Economical and Ecological DishwashingDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Control Panel Multi-Display can displayPrior to using for the first time Special salt Adjusting the Water SoftenerYour area Electronic adjustment Filling with Salt for the Water Softener Fill with dishwasher saltUse dishwasher salt Open the door, remove the lower Rack Turning it anticlockwiseRinse Aid Switching Rinse Aid Supply On and OffThere are two ways to add rinse aid Filling with Rinse Aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Tioned horizontally in the upper basketPlace knives, small spoons and small Forks in the cutlery trayLoading Pans, Frying Pans Large Plates Loading Cups, Glasses and Coffee Services Fold the plate insert to the leftLowering the Upper Basket Adjusting the Height of the Upper BasketRaising the Upper Basket Filling with Detergent Fill with detergentDetergent tablets Concentrated DetergentAutomatic Wash Programmes Selecting the Wash Programme Programme Table SoilingChanging/Interrupting/Cancelling Start the Wash ProgrammeWash Programme Changing the wash programmeSetting or Changing the Delay Start Timer Cancelling the wash programmeDishwasher is switched on again Changing the delay startSwitching Off the Dishwasher Load Sensing Sensor LogicEmptying the Dishwasher Immediately after the end of the programmeCare and Cleaning Cleaning the FilterWhat to do, if StancesError messages Symptom Possible Cause SolutionThere are problems with the operation of the dish- washer Wash results are not satisfactoryDishes are still dirty Wrong wash programme was selectedTechnical Data Dishes are wet and dullRinse aid was not used Rinse aid container is empty Lower rinse aid dosingUpper basket without cutlery tray Sample loading arrangementsLower basket with cutlery basket Installing the Dishwasher See enclosed installation instructionsBuilt-Under Dishwasher Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedConnecting the Dishwasher Water ConnectionPermitted water pressure Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Customer Care 08705 929Calls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG