Electrolux 60820 manual Care and Cleaning, Cleaning the Filter

Page 28

Operating Instructions

Care and Cleaning

1

Do not under any circumstances use furniture care products or aggres-

 

sive cleaners.

 

• If necessary, clean the controls only with a soft cloth and pure warm

 

water.

 

• Occasionally check the internal containers, door seal, and water inlet

 

for soiling, clean if necessary.

 

Cleaning the Filter

3

The filters should be checked and

 

cleaned regularly. Dirty filters will

 

give poor wash results.

0 1.

Open the door, remove the lower

 

rack.

2.

The dishwasher filter system com-

 

prises a coarse/fine filter, microfilter

 

and a flat filter. Unlock the filter sys-

 

tem using the handle on the microfil-

 

ter, and remove.

3.

Turn the handle about ¼ a turn anti-

 

clockwise and remove.

4.

Take hold of the coarse/fine filter

 

(1/2) by the handle with the hole and

 

remove from the microfilter (3)

5.

Clean all filters thoroughly under

 

running water.

6.

Remove the flat filter (4) from the

 

base of the washing compartment

 

and clean both faces thoroughly

28

Image 28
Contents Favorit Tips on using the appliance Dear customerPlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions What to do, ifSafety Instructions Installation, Connection and Placing into OperationChild Safety General SafetyCorrect Use Disposal Economical and Ecological DishwashingDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Control Panel Multi-Display can displayPrior to using for the first time Special salt Adjusting the Water SoftenerYour area Electronic adjustment Filling with Salt for the Water Softener Fill with dishwasher saltUse dishwasher salt Open the door, remove the lower Rack Turning it anticlockwiseRinse Aid Switching Rinse Aid Supply On and OffThere are two ways to add rinse aid Filling with Rinse Aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Tioned horizontally in the upper basketPlace knives, small spoons and small Forks in the cutlery trayLoading Pans, Frying Pans Large Plates Loading Cups, Glasses and Coffee Services Fold the plate insert to the leftLowering the Upper Basket Adjusting the Height of the Upper BasketRaising the Upper Basket Filling with Detergent Fill with detergentDetergent tablets Concentrated DetergentAutomatic Wash Programmes Selecting the Wash Programme Programme Table SoilingChanging/Interrupting/Cancelling Start the Wash ProgrammeWash Programme Changing the wash programmeSetting or Changing the Delay Start Timer Cancelling the wash programmeDishwasher is switched on again Changing the delay startSwitching Off the Dishwasher Load Sensing Sensor LogicEmptying the Dishwasher Immediately after the end of the programmeCare and Cleaning Cleaning the FilterWhat to do, if StancesError messages Symptom Possible Cause SolutionThere are problems with the operation of the dish- washer Wash results are not satisfactoryDishes are still dirty Wrong wash programme was selectedTechnical Data Dishes are wet and dullRinse aid was not used Rinse aid container is empty Lower rinse aid dosingUpper basket without cutlery tray Sample loading arrangementsLower basket with cutlery basket Installing the Dishwasher See enclosed installation instructionsBuilt-Under Dishwasher Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedConnecting the Dishwasher Water ConnectionPermitted water pressure Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Customer Care 08705 929Calls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG