Electrolux 60820 manual Correct Use

Page 6

Operating Instructions

Never place the dishwasher in operation if the mains cable, water inlet or drain hose is damaged; or the control panel, work top or plinth area is damaged such that the inside of the appliance is freely accessible.

If the mains lead is damaged, or is to be replaced for a longer lead, the cable (obtainable from AEG Service Force) must be changed by a service engineer authorised by AEG.

Never unplug the appliance by pulling on the cable, always pull the plug.

Additions or modifications to the dishwasher are not permitted for safety reasons.

Ensure that the door of the dishwasher is always closed when it is not being loaded or unloaded. In this way you will avoid anybody tripping over the open door and hurting themselves.

Long bladed knives stored in an upright position are a potential haz- ard.

Sharp knives and items of cutlery with sharp edges must be placed in the cutlery tray or in the upper rack.

When finished loading or unloading, close the door as an open door can be a hazard.

Correct Use

Only wash household dishes using the dishwasher. If the appliance is used for other purposes, or is used incorrectly, the manufacturer can- not accept any liability for any damage caused.

Only use detergents specifically designed for use in domestic dish- washers.

Do not put any solvents in the dishwasher. There is a risk of an explo- sion!

The anti-flood system provides dependable protection against dam- age due to leaks. For this system to function correctly, the following preconditions must be met:

The appliance must remain connected to the mains even when it is switched off.

The dishwasher must be correctly installed.

Always shut off the water supply at the tap when the dishwasher is not to be used for longer periods, e.g. when you are away on holi- day.

6

Image 6
Contents Favorit Please read these user instructions carefully Tips on using the applianceDear customer Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions What to do, ifChild Safety Safety InstructionsInstallation, Connection and Placing into Operation General SafetyCorrect Use Disposing of the Packaging Material DisposalEconomical and Ecological Dishwashing Disposal of Old AppliancesAppliance Features and Control Panel Control Panel Multi-Display can displayPrior to using for the first time Adjusting the Water Softener Special saltYour area Electronic adjustment Use dishwasher salt Open the door, remove the lower Rack Filling with Salt for the Water SoftenerFill with dishwasher salt Turning it anticlockwiseSwitching Rinse Aid Supply On and Off Rinse AidThere are two ways to add rinse aid Filling with Rinse Aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherPlace knives, small spoons and small Loading CutleryTioned horizontally in the upper basket Forks in the cutlery trayLoading Pans, Frying Pans Large Plates Loading Cups, Glasses and Coffee Services Fold the plate insert to the leftAdjusting the Height of the Upper Basket Lowering the Upper BasketRaising the Upper Basket Filling with Detergent Fill with detergentConcentrated Detergent Detergent tabletsAutomatic Wash Programmes Selecting the Wash Programme Programme Table SoilingWash Programme Changing/Interrupting/CancellingStart the Wash Programme Changing the wash programmeDishwasher is switched on again Setting or Changing the Delay Start TimerCancelling the wash programme Changing the delay startEmptying the Dishwasher Switching Off the DishwasherLoad Sensing Sensor Logic Immediately after the end of the programmeCare and Cleaning Cleaning the FilterWhat to do, if StancesError messages Symptom Possible Cause SolutionDishes are still dirty There are problems with the operation of the dish- washerWash results are not satisfactory Wrong wash programme was selectedRinse aid was not used Rinse aid container is empty Technical DataDishes are wet and dull Lower rinse aid dosingSample loading arrangements Upper basket without cutlery trayLower basket with cutlery basket Built-Under Dishwasher Installing the DishwasherSee enclosed installation instructions Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedPermitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions 08705 929 Customer CareCalls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG