Electrolux 60820 manual Work surface must be re-mounted

Page 35

Installation and Connection Instructions

0 1. Unscrew the screws from the posi- tioning plates on the back (1).

2.Slide the appliance's work surface

approx. 1 cm to the rear (2).

3. Lift the work surface at the front (3) and remove.

1	If the dishwasher is later used as a free-standing appliance, the original
	work surface must be re-mounted.
3	The plinth on free-standing appliances is not adjustable.

Image 35

Contents Favorit Pass them on to any subsequent owner of the appliance Tips on using the applianceDear customer Please read these user instructions carefullyContents What to do, if Installation and Connection InstructionsGeneral Safety Safety InstructionsInstallation, Connection and Placing into Operation Child SafetyCorrect Use Disposal of Old Appliances DisposalEconomical and Ecological Dishwashing Disposing of the Packaging MaterialAppliance Features and Control Panel Multi-Display can display Control PanelPrior to using for the first time Your area Adjusting the Water SoftenerSpecial salt Electronic adjustment Turning it anticlockwise Filling with Salt for the Water SoftenerFill with dishwasher salt Use dishwasher salt Open the door, remove the lower RackThere are two ways to add rinse aid Switching Rinse Aid Supply On and OffRinse Aid Fully open the rinse aid compartment lid Filling with Rinse AidDaily Use Adjusting Rinse Aid DosingNot be washed in the dishwasher Loading Cutlery and DishesForks in the cutlery tray Loading CutleryTioned horizontally in the upper basket Place knives, small spoons and smallLoading Pans, Frying Pans Large Plates Fold the plate insert to the left Loading Cups, Glasses and Coffee ServicesRaising the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Fill with detergent Filling with DetergentAutomatic Wash Programmes Concentrated DetergentDetergent tablets Soiling Selecting the Wash Programme Programme TableChanging the wash programme Changing/Interrupting/CancellingStart the Wash Programme Wash ProgrammeChanging the delay start Setting or Changing the Delay Start TimerCancelling the wash programme Dishwasher is switched on againImmediately after the end of the programme Switching Off the DishwasherLoad Sensing Sensor Logic Emptying the DishwasherCleaning the Filter Care and CleaningStances What to do, ifSymptom Possible Cause Solution Error messagesWrong wash programme was selected There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are still dirtyLower rinse aid dosing Technical DataDishes are wet and dull Rinse aid was not used Rinse aid container is emptyLower basket with cutlery basket Sample loading arrangementsUpper basket without cutlery tray Free-Standing Appliances Installing the DishwasherSee enclosed installation instructions Built-Under DishwasherWork surface must be re-mounted Plinth on free-standing appliances is not adjustableConnect the inlet hose Connecting the DishwasherWater Connection Permitted water pressurePlease take care when installing the water inlet hose Water inlet hose with safety valveWater drain Appliance is automatically pumped out Leak Prevention SystemChanging a fuse Electrical ConnectionConnections Guarantee Conditions Calls may be recorded for training purposes 08705 929Customer Care AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG

work surface must be re-mounted.

The plinth on free-standing appliances is not adjustable.