Electrolux 60820 Load Sensing Sensor Logic, Switching Off the Dishwasher, Emptying the Dishwasher

Page 27

Operating Instructions

Load Sensing – Sensor Logic

If a wash programme is started even though there are only a few dishes in the upper and/or lower rack, an intelligent electronic system adjusts the amount of water and the duration of the wash programme to the number of dishes. By this means it is possible to wash only a few dishes quickly and economically. At half load (6 place settings), up to 2 litres of water and 0.2 kWh of electricity are saved.

Switching Off the Dishwasher

Switch the dishwasher off when the multi-display indicates "0" for the remaining programme time.

0 1. Press the ON/OFF button. The ON/OFF button indicator extinguishes.

1	Hot steam may escape from the appliance when opening the door
	immediately after the end of the programme.

2.Open the door carefully, as steam may escape.

	Emptying the Dishwasher
3	• The dishes should therefore be allowed to cool down before removing
	them from the appliance, as hot dishes can be sensitive to knocks.

• Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down.

• First empty the lower rack, and then the upper rack. This will avoid any water that may be remaining in the upper rack, dripping onto the dishes in the lower rack and leaving water marks.

27

Image 27

Contents Favorit Pass them on to any subsequent owner of the appliance Tips on using the applianceDear customer Please read these user instructions carefullyContents What to do, if Installation and Connection InstructionsGeneral Safety Safety InstructionsInstallation, Connection and Placing into Operation Child SafetyCorrect Use Disposal of Old Appliances DisposalEconomical and Ecological Dishwashing Disposing of the Packaging MaterialAppliance Features and Control Panel Multi-Display can display Control PanelPrior to using for the first time Adjusting the Water Softener Special saltYour area Electronic adjustment Turning it anticlockwise Filling with Salt for the Water SoftenerFill with dishwasher salt Use dishwasher salt Open the door, remove the lower RackSwitching Rinse Aid Supply On and Off Rinse AidThere are two ways to add rinse aid Fully open the rinse aid compartment lid Filling with Rinse AidDaily Use Adjusting Rinse Aid DosingNot be washed in the dishwasher Loading Cutlery and DishesForks in the cutlery tray Loading CutleryTioned horizontally in the upper basket Place knives, small spoons and smallLoading Pans, Frying Pans Large Plates Fold the plate insert to the left Loading Cups, Glasses and Coffee ServicesAdjusting the Height of the Upper Basket Lowering the Upper BasketRaising the Upper Basket Fill with detergent Filling with DetergentConcentrated Detergent Detergent tabletsAutomatic Wash Programmes Soiling Selecting the Wash Programme Programme TableChanging the wash programme Changing/Interrupting/CancellingStart the Wash Programme Wash ProgrammeChanging the delay start Setting or Changing the Delay Start TimerCancelling the wash programme Dishwasher is switched on againImmediately after the end of the programme Switching Off the DishwasherLoad Sensing Sensor Logic Emptying the DishwasherCleaning the Filter Care and CleaningStances What to do, ifSymptom Possible Cause Solution Error messagesWrong wash programme was selected There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are still dirtyLower rinse aid dosing Technical DataDishes are wet and dull Rinse aid was not used Rinse aid container is emptySample loading arrangements Upper basket without cutlery trayLower basket with cutlery basket Free-Standing Appliances Installing the DishwasherSee enclosed installation instructions Built-Under DishwasherWork surface must be re-mounted Plinth on free-standing appliances is not adjustableConnect the inlet hose Connecting the DishwasherWater Connection Permitted water pressurePlease take care when installing the water inlet hose Water inlet hose with safety valveWater drain Appliance is automatically pumped out Leak Prevention SystemChanging a fuse Electrical ConnectionConnections Guarantee Conditions 08705 929 Customer CareCalls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG