Electrolux 60820 manual What to do, if, Stances

Page 29

Operating Instructions

7.Put the flat filter back in the base of

the washing compartment

8.Place the coarse/fine filter in the

microfilter and press together.

9. Put the filter combination in place and lock by turning the handle clock- wise to the stop. During this process ensure that the flat filter does not protrude above the base of the wash- ing compartment.

1	The dishwasher must not be used
	without filters under any circum-

stances.

What to do, if ...

Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.

Image 29

Contents Favorit Dear customer Tips on using the appliancePlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents What to do, if Installation and Connection InstructionsInstallation, Connection and Placing into Operation Safety InstructionsChild Safety General SafetyCorrect Use Economical and Ecological Dishwashing DisposalDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Multi-Display can display Control PanelPrior to using for the first time Your area Adjusting the Water SoftenerSpecial salt Electronic adjustment Fill with dishwasher salt Filling with Salt for the Water SoftenerUse dishwasher salt Open the door, remove the lower Rack Turning it anticlockwiseThere are two ways to add rinse aid Switching Rinse Aid Supply On and OffRinse Aid Fully open the rinse aid compartment lid Filling with Rinse AidDaily Use Adjusting Rinse Aid DosingNot be washed in the dishwasher Loading Cutlery and DishesTioned horizontally in the upper basket Loading CutleryPlace knives, small spoons and small Forks in the cutlery trayLoading Pans, Frying Pans Large Plates Fold the plate insert to the left Loading Cups, Glasses and Coffee ServicesRaising the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Fill with detergent Filling with DetergentAutomatic Wash Programmes Concentrated DetergentDetergent tablets Soiling Selecting the Wash Programme Programme TableStart the Wash Programme Changing/Interrupting/CancellingWash Programme Changing the wash programmeCancelling the wash programme Setting or Changing the Delay Start TimerDishwasher is switched on again Changing the delay startLoad Sensing Sensor Logic Switching Off the DishwasherEmptying the Dishwasher Immediately after the end of the programmeCleaning the Filter Care and CleaningStances What to do, ifSymptom Possible Cause Solution Error messagesWash results are not satisfactory There are problems with the operation of the dish- washerDishes are still dirty Wrong wash programme was selectedDishes are wet and dull Technical DataRinse aid was not used Rinse aid container is empty Lower rinse aid dosingLower basket with cutlery basket Sample loading arrangementsUpper basket without cutlery tray See enclosed installation instructions Installing the DishwasherBuilt-Under Dishwasher Free-Standing AppliancesWork surface must be re-mounted Plinth on free-standing appliances is not adjustableWater Connection Connecting the DishwasherPermitted water pressure Connect the inlet hosePlease take care when installing the water inlet hose Water inlet hose with safety valveWater drain Appliance is automatically pumped out Leak Prevention SystemChanging a fuse Electrical ConnectionConnections Guarantee Conditions Calls may be recorded for training purposes 08705 929Customer Care AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG