Electrolux 60820 manual Sample loading arrangements, Upper basket without cutlery tray

Page 33

Operating Instructions

Notes for Test Institutes

Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table).

Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see Programme Table).

	Full Load:		Half Load:
	12 place settings		6 place settings incl. serving dishes,
	incl. serving dishes		leaving alternate positions free
Detergent Dosing:	5g + 25g (Type B)		20g (Type B)
Rinse Aid Setting:	4 (Type III)		4 (Type III)

Sample loading arrangements:
Upper basket without cutlery tray		Upper basket with cutlery tray

Lower basket with cutlery basket

Cutlery basket

Image 33

Contents Favorit Dear customer Tips on using the appliancePlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents What to do, if Installation and Connection InstructionsInstallation, Connection and Placing into Operation Safety InstructionsChild Safety General SafetyCorrect Use Economical and Ecological Dishwashing DisposalDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Multi-Display can display Control PanelPrior to using for the first time Adjusting the Water Softener Special saltYour area Electronic adjustment Fill with dishwasher salt Filling with Salt for the Water SoftenerUse dishwasher salt Open the door, remove the lower Rack Turning it anticlockwiseSwitching Rinse Aid Supply On and Off Rinse AidThere are two ways to add rinse aid Fully open the rinse aid compartment lid Filling with Rinse AidDaily Use Adjusting Rinse Aid DosingNot be washed in the dishwasher Loading Cutlery and DishesTioned horizontally in the upper basket Loading CutleryPlace knives, small spoons and small Forks in the cutlery trayLoading Pans, Frying Pans Large Plates Fold the plate insert to the left Loading Cups, Glasses and Coffee ServicesAdjusting the Height of the Upper Basket Lowering the Upper BasketRaising the Upper Basket Fill with detergent Filling with DetergentConcentrated Detergent Detergent tabletsAutomatic Wash Programmes Soiling Selecting the Wash Programme Programme TableStart the Wash Programme Changing/Interrupting/CancellingWash Programme Changing the wash programmeCancelling the wash programme Setting or Changing the Delay Start TimerDishwasher is switched on again Changing the delay startLoad Sensing Sensor Logic Switching Off the DishwasherEmptying the Dishwasher Immediately after the end of the programmeCleaning the Filter Care and CleaningStances What to do, ifSymptom Possible Cause Solution Error messagesWash results are not satisfactory There are problems with the operation of the dish- washerDishes are still dirty Wrong wash programme was selectedDishes are wet and dull Technical DataRinse aid was not used Rinse aid container is empty Lower rinse aid dosingSample loading arrangements Upper basket without cutlery trayLower basket with cutlery basket See enclosed installation instructions Installing the DishwasherBuilt-Under Dishwasher Free-Standing AppliancesWork surface must be re-mounted Plinth on free-standing appliances is not adjustableWater Connection Connecting the DishwasherPermitted water pressure Connect the inlet hosePlease take care when installing the water inlet hose Water inlet hose with safety valveWater drain Appliance is automatically pumped out Leak Prevention SystemChanging a fuse Electrical ConnectionConnections Guarantee Conditions 08705 929 Customer CareCalls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG

Full Load:

Half Load:

Sample loading arrangements:

Upper basket without cutlery tray

Lower basket with cutlery basket