Electrolux 60820 manual Technical Data, Dishes are wet and dull, Lower rinse aid dosing

Page 32

Operating Instructions

The dishes are wet and dull.

Rinse aid was not used.

The rinse aid container is empty.

There are streaks, milky spots or a bluish coating on glasses and dishes.

– Lower rinse aid dosing.

There are dried water drops on the glasses and dishes.

Increase rinse aid dosing.

The detergent may be the cause. Contact the detergent manufac- turer’s customer advisor.

Technical Data

Capacity:

12 place settings including serving dishes

Permitted Water

1-10 bar (=10-100 N/cm2 = 0.1-1.0 MPa)

Pressure:

 

Electrical Connection:

Information on the electrical connection is given on the

rating plate on the inner edge of the dishwasher door on

 

 

the right.

 

 

Dishwasher: Free-Standing Appliances

Dimensions:

850 x 600 x 600 (H x W x D in mm)

Max. Weight:

54 Kg

Dishwashers that Can Be Integrated, Built-In Dishwashers

Dimensions:

820 – 880 x 596 x 570 (H x W x D in mm)

Max. Weight:

50 Kg

Dishwashers that Can Be Fully Integrated

Dimensions:

820 – 880 x 596 x 546 - 550 (H x W x D in mm)

Max. Weight:

50 Kg

 

 

;This appliance conforms with the following EU Directives:

73/23/EWG dated 19. 02. 1973 – Low Voltage Directive

89/336/EWG dated 03. 05. 1989

(including Directive Amendment 92/31/EWG) – EMC Directive

32

Image 32
Contents Favorit Tips on using the appliance Dear customerPlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions What to do, ifSafety Instructions Installation, Connection and Placing into OperationChild Safety General SafetyCorrect Use Disposal Economical and Ecological DishwashingDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Control Panel Multi-Display can displayPrior to using for the first time Your area Adjusting the Water SoftenerSpecial salt Electronic adjustment Filling with Salt for the Water Softener Fill with dishwasher saltUse dishwasher salt Open the door, remove the lower Rack Turning it anticlockwiseThere are two ways to add rinse aid Switching Rinse Aid Supply On and OffRinse Aid Filling with Rinse Aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Tioned horizontally in the upper basketPlace knives, small spoons and small Forks in the cutlery trayLoading Pans, Frying Pans Large Plates Loading Cups, Glasses and Coffee Services Fold the plate insert to the leftRaising the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Filling with Detergent Fill with detergentAutomatic Wash Programmes Concentrated DetergentDetergent tablets Selecting the Wash Programme Programme Table SoilingChanging/Interrupting/Cancelling Start the Wash ProgrammeWash Programme Changing the wash programmeSetting or Changing the Delay Start Timer Cancelling the wash programmeDishwasher is switched on again Changing the delay startSwitching Off the Dishwasher Load Sensing Sensor LogicEmptying the Dishwasher Immediately after the end of the programmeCare and Cleaning Cleaning the FilterWhat to do, if StancesError messages Symptom Possible Cause SolutionThere are problems with the operation of the dish- washer Wash results are not satisfactoryDishes are still dirty Wrong wash programme was selectedTechnical Data Dishes are wet and dullRinse aid was not used Rinse aid container is empty Lower rinse aid dosingLower basket with cutlery basket Sample loading arrangementsUpper basket without cutlery tray Installing the Dishwasher See enclosed installation instructionsBuilt-Under Dishwasher Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedConnecting the Dishwasher Water ConnectionPermitted water pressure Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Calls may be recorded for training purposes 08705 929Customer Care AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG