FGP55 SERIES RETHERMALIZERS
CHAPTER 3: OPERATING INSTRUCTIONS
3.1 Introduction
The FGP55 rethermalizer is offered with a standing pilot with Piezo ignitor or electronic ignition. The unit is equipped with a
Cold food should not be added to the cookpot, if the rethermalizer is in the
3.2 Lighting Instructions
CAUTION
Vessel MUST be filled with water before lighting.
Follow these instructions for units equipped with a standing pilot:
1.Press the switch to turn the computer ON. If the vessel is not filled to the proper level
with water, the AutoFill feature will add water to the proper level.
2.Turn the gas valve knob (open the door to gain access) to the OFF position. Wait 5 minutes before proceeding.
3.Turn the gas valve knob to the PILOT position.
4.Push and hold the knob in. Simultaneously, press the Piezo ignitor button repeatedly until the pilot lights. Continue to depress the gas valve pilot knob approximately 60 seconds. Release the knob.
5.The pilot flame should remain lit. If the pilot goes out, wait at least 5 minutes, then follow Step 4 to
6.Turn the gas valve knob to the ON position.
7.An illuminated dot between digits 1 and 2 in either LED display indicates that the burners are lit.
8.If the burners fail to light, press the switch to turn the computer OFF and wait 60 seconds. Repeat the preceding steps.
NO |
|
| OFF |
|
|
| |
|
|
| P |
|
|
| I |
|
| L | |
| O |
| |
| T |
|
|
O | F | F |
| ||
|
|
P
I
L
TO
NO
| OT |
|
L |
| |
I |
|
|
P |
|
|
FFO |
| ON |
|
|