Operations
■Notes:
•Before operating this receiver, first set this unit as desired for optimum performance, doing the system setup procedures. (For details, refer to “System Setup” on page 34)
LISTENING TO A PROGRAM SOURCE
Before operation
•Enter the standby mode.
•The POWER ON/STANDBY button lights up . This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the operation readiness.
•To switch the power off, push the POWER switch again.
•Then the power is cut off and the POWER ON / STANDBY button goes off.
1. In the standby mode, turn the power on.
•Each time the POWER ON/STANDBY button on the front panel is pressed, the receiver is turned on to enter the operating mode or off to enter the standby mode.
•On the remote control, press the POWER ON button to enter the operating mode or press the STANDBY button to enter the standby mode.
•In the standby mode, if the INPUT SELECTOR button is pressed, the receiver is turned on automatically and the desired input is selected.
2.Switch the speakers on.
•Then the SPEAKER indicator lights up and the sound can be heard from the speakers connected to the speaker terminals.
•When using the headphone for private listening, press the SPEAKER button again to switch the speakers off.
3. Select the desired input source.
•Each time the "VIDEO" button on the front panel is pressed, the input source changes as follows:
→VIDEO 1 → VIDEO 2 → VIDEO 3 
•Each time the "AUDIO" button on the front panel is pressed, the input source changes as follows:
→CD → AUX → TAPE
•Each time the BAND button is pressed, the band changes as follows;
→FM ST → FM MONO → AM → XM 
■When selecting the EXTERNAL IN as desired,
•Depending on the surround back speaker setting, "EXT IN" is displayed and 8(/7/6) separate analog signals from the component connected to this input pass through the tone and volume circuits only and can be heard from your speakers.
•Press the EXTERNAL IN button or select the desired input source to cancel the external in function.
•These analog signals can be heard only, not recorded.
ENGLISH
15