ENGLISH
System Setup
•The setup menu is displayed on the fluorescent display and allows you to perform the setup procedures easily. In most situations, you will only need to set this once during the installation and layout of your home theater, and it rarely needs to be changed later.
The setup menu consists of 5 main menus ; system , input, speaker setup, CH level and parameter. These menus are then divided up into various
■Navigating through the setup menu
•The explanations here assume you are using the buttons on the remote control when performing the setup menu operation. However, you can use the buttons on the front panel as well.
The buttons on the front panel correspond to those on the remote control as shown below.
1. Turn the setup menu on.
2. Select the desired menu using the CURSOR UP(▲) /
DOWN(▼) buttons.
•The setup menu will be shown.
•To turn the menu off, press this button again.
3.Confirm your selection.
• When selecting “SYSTEM”, see “SETTING THE SYSTEM” on page 37.
• When selecting “INPUT”, see “SETTING THE INPUT” on page 39.
• When selecting “SPK SET”, see “SETTING THE SPEAKER SETUP” on page 41.
• When selecting “CH LEVEL”, see “SETTING THE CH LEVEL” on page 48.
• When selecting “PARAMTR”, see “SETTING THE SOUND PARAMETER” on page 50.
• When selecting “EXIT”, the setup menu will be turned off.
34