Adjusting the tone (bass and treble)
9. Enter the tone mode.
ENGLISH
• The tone mode is displayed for several seconds.
■Note : When the digital signals from DTS, Dolby Digital program sources are input or the EXTERNAL IN is selected can listen to a program source without the tone effect.
10. Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to
select the desired tone mode.
•Each time these buttons are pressed, the tone mode is selected as follows:
OFF : To listen to a program source without the tone effect. (“DIRECT” indicator lights up.)
ON : To adjust the tone for your taste. (“DIRECT” indicator goes off.)
■When the “TONE” is set to ON to adjust the tone (bass and treble).
11. Press the CURSOR UP(▲)/DOWN(▼) buttons to
select the desired tone.
•Each time these buttons are pressed, the tone is selected as follows:
BASS TRBL(treble) TONE ON
12. Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to
adjust the selected tone as desired.
•The tone level can be adjusted within the range of
•In general, we recommend the bass and treble to be adjusted to 0 dB (flat level).
•Extreme settings at high volume may damage your speakers.
•To complete tone adjustment, repeat the above steps 11 and 12.
•If the tone display disappears, start from the step 9 again.
17