The unit doesn’t turn on .
●You poured in water directly from a tap.
●You put the unit on the sink.
●You turned the unit upside down with its bottom wet.
●You washed the unit in water.
●If the electric components get wet, the unit must be repaired. Contact the store where you purchased the unit for repair.
Replacement
●If the problem cannot be resolved, or if you think something is still wrong with the unit, disconnect the plug, reconnect after 30 seconds and operate it again.
●Inside lid may turn yellow, but operation will not be affected.
●
●Outside body becomes 113°F(45°C) while warm keep if the room temperature is high.
The indicator lights flash |
| ● This is a malfunction of the sensor. Contact the retailer where you |
alternately and displays | . | purchased the unit. |
Replacement of Parts
Rubber gasket set | Mesh filter |
Replace gaskets if they crack, lose their pliancy | Replace the filter if foreign materials which |
or, for any other reasons which allow steam to | clog the filter cannot be removed even after |
escape from between the container and the lid. | you scrub with a cleaning brush, etc. |
of Parts
Lid cover
Set gaskets
Remove lid, unscrew 3 tapping screws and remove the lid cover.
Exchange the gaskets and then place the lid cover back and secure with the tapping screws.
Consumable parts are available from an authorized dealer.
Part name | Part No. |
Rubber gasket set | |
Mesh filter |
23