INSTALLATION REQUIREMENTS
Tools and Parts
Parts Supplied
Check that all parts are included.
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Tools needed
A 
BC D
■ | Pliers | ■ | 10" adjustable wrench |
■ | Phillips screwdriver | ■ | Utility knife |
■ | ■ | Level | |
■ ³⁄₁₆" and ¼" nut drivers or | ■ | Electric drill | |
| hex sockets | ■ | ¹⁄₈" drill bit |
|
| ||
■Measuring tape or ruler
■1½" hole saw bit
Parts needed
B
A 
C
A. 72" (182.9 cm) flexible water supply line
B. Zip tie
C. 2 appropriate sized UL listed wire connectors
EF 
IG
J H 
K 
L
M 
N
A. ³⁄₄" UL listed strain relief B. 1.25" hose clamp
C. 8 mounting bracket screws D. 4 unit mounting screws E. Drain hose connector
F. 4 mounting brackets
G. Drain connector spring clamps
H. 2 trim strips
I. Toe kick brackets
J. 2 toe kick bracket screws K. Toe kick trim
L. 2 panel fasteners (on some models)
M. 10 TORX®† screws (on some models)
N. Drain hose
Location Requirements
IMPORTANT: Observe all governing codes and ordinances. Failure to meet codes and ordinances could lead to fire or electrical shock.
Proper installation is your responsibility.
■Contact a qualified installer to ensure that the dishwasher is installed to meet all electrical and plumbing national and local codes and ordinances.
■Install the dishwasher as specified in these instructions.
■Have everything you need to properly install dishwasher.
■Keep the dishwasher and water lines leading to dishwasher from freezing. Damage from freezing is not covered by the warranty.
■This dishwasher is manufactured for indoor use only.
■Install and level dishwasher on a floor that will hold the weight, and in an area suitable for its size and use.
4