Maytag MGR6775ADB/Q/S/W, MGR6875ADB/Q/S/W manual No gas flows to burner Ignitor glows red

Page 15

Troubleshooting Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power and gas to oven before servicing, unless testing requires power and/or gas.

Problem

Possible Cause

 

Failed ignitor

 

Gas pressure too high

No gas flows to burner.

 

Ignitor glows red.

 

 

Failed gas valve

 

Loose wire connection or broken wire

 

 

 

Ignitor positioned too far from burner

 

Dirt or grease in orifice or burner

 

Insufficient gas pressure

Gas flows to bake/broil

 

burner, but burner does not

 

light.

Power outage

 

Power outage ..............................................

Broil burner shuts off shortly after the start of self-clean operation. Bake and broil

functions operate normally.

Control Error ................................................

No power to fan motor.................................

Fan motor does not operate.

Failed fan motor or winding/frozen shaft .....

Correction

Check ignitor current draw, 3.2 – 3.6 Amps. Replace ignitor, if it fails test.

Check for correct gas pressure. Natural gas pressure should be 4" WCP and LP gas pressure should be 10" WCP.

Check gas valve for continuity.

Verify all connections are clean and tight, replace broken wire.

Reposition ignitor closer to bake/broil burner.

Clean orifice or burner.

Check for correct gas pressure. Natural gas pressure should be 5" WCP and LP gas pressure should be 10" WCP.

Verify power is present at unit. Verify that the circuit breaker is not tripped.

Replace household fuse, but do not fuse capacity.

Verify power is present at unit. Verify that the circuit breaker is not tripped.

Replace household fuse, but do not fuse capacity.

See “Control Systems Troubleshooting.”

Check for 120 VAC supplied at fan motor. If no voltage is present, check for broken or loose wiring between fan motor and relay board. If voltage is present at fan motor, go to the next step.

Check motor winding for continuity. Check for a frozen motor shaft. Check for broken wiring between motor and neutral terminal block.

©2004 Maytag Services

16023415

15

Image 15
Contents Service Important Information Customer Service Support CenterTable of Contents Servicing Safety Practices for ServicerReceiving Oven Using the OvenElectrical Requirements Connecting Range to GasProduct Safety Devices Baking, Broiling, and RoastingGeneral Information Parts and Accessories SpecificationsPlacement of the Oven ServiceGrounding ArningRange Description Troubleshooting Procedures 16023415 Maytag Services Maytag Services 16023415 Component Troubleshooting No gas flows to burner Ignitor glows red Check lamp and replace is necessary Testing Procedures Testing Procedures Illustration/Component Test Procedure H2 Control Testing Model MGR6875AA H3 Control Testing Model MGR6775AA Quick Test Mode for Electronic Range Control This mode will also display the current fault code for Leveling Legs Top Surface Valve and Spark SwitchTop Burner Lower Assembly Moving and/or Replacing RangeOven Doors Oven Light ReplacementOven Sensor Electronic ClockGasket and Door Disassembly Upper Latch Assembly Lower Latch AssemblyGas Valve Convection AssemblyOven Door Hinge RegulatorOven Racks Oven Cavity Components GasRack Positions Appendix a Maytag Double Oven Gas Range Double Oven Gas Range Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Appendix B Pilotless Ignition Suggested Heat SettingsOperating During a Power Failure Surface ControlsTo prevent the cooktop from discoloring or staining Surface CookingTo set the Clock To change the clock to 24-hour formatLocking the Control Oven Doors TimerFault Codes Adjusting the Sound LevelTo set bake Return To Factory Default SettingsSetting Upper and Lower Oven Functions Baking Cook & HoldDelay Cook & Hold Keep Warm Adjusting the Oven TemperatureTo cancel Keep Warm To adjust the oven temperatureTo set Broil Broiling upper oven onlyOven Bottom Automatic Shut-Off/Sabbath ModeOven Vent Oven LightsTo replace oven racks Upper ovenLower oven To remove oven racksSurface Cooking Surface Cooking Using the Touchpads Control PanelClock Adjusting Sound Level Setting Oven Functions Baking with ConvectionTo set Convect Bake To set Convect Roast Roasting With ConvectionBroiling upper oven only Broiling Chart Broil times are based on a 5 minute preheatOven Cooking To cancel a Favorite cycle in progress FavoriteTo start a cycle programmed into Favorite Sabbath Mode Notes Rack Positions lower oven Care & Cleaning Do not USE ANY Cleaning Product Containing Chlorine Bleach Appendix C LP Conversion Instructions LP Conversion Instructions LP Conversion Instructions LP Conversion Instructions