Maytag MGR6775ADB/Q/S/W, MGR6875ADB/Q/S/W manual Lower Latch Assembly, Upper Latch Assembly

Page 27

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury, or death: disconnect electrical and gas supply before servicing.

Upper Oven Door

Lower Latch Assembly

NOTE: Removal of range from installation position is required.

1.Disconnect power before servicing.

2.Remove oven door, see "Oven Door(s)-Door Removal" procedure.

3.Remove range from installation position, see "Move and/or Replacing Range" procedure.

4.Remove maintop, see "Maintop Removal" procedure. (Perform steps 1 – 6.)

5.Remove left side panel, see "Side Panel" procedure.

6.Disconnect and label wiring from door lock switch and motor.

7.Remove screws securing latch assembly and slide assembly from range.

8.Reverse procedure to reassemble.

Upper Latch Assembly

1.Disconnect power before servicing.

2.Remove oven door, see "Oven Door(s)-Door Removal" procedure.

3.Remove maintop, see "Maintop Removal" procedure. (Perform steps 1 – 6.)

4.Disconnect and label wiring from door lock switch and motor.

5.Remove screws securing latch assembly and slide assembly from range.

6.Reverse procedure to reassemble.

©2004 Maytag Services

16023415

27

Image 27

Contents Service Important Information Customer Service Support CenterTable of Contents Servicing Safety Practices for ServicerReceiving Oven Using the OvenElectrical Requirements Connecting Range to GasProduct Safety Devices Baking, Broiling, and RoastingGeneral Information Parts and Accessories SpecificationsPlacement of the Oven ServiceGrounding ArningRange Description Troubleshooting Procedures 16023415 Maytag Services Maytag Services 16023415 Component Troubleshooting No gas flows to burner Ignitor glows red Check lamp and replace is necessary Testing Procedures Testing Procedures Illustration/Component Test Procedure H2 Control Testing Model MGR6875AA H3 Control Testing Model MGR6775AA Quick Test Mode for Electronic Range Control This mode will also display the current fault code for Leveling Legs Top Surface Valve and Spark SwitchTop Burner Lower Assembly Moving and/or Replacing RangeOven Doors Oven Light ReplacementOven Sensor Electronic ClockGasket and Door Disassembly Upper Latch Assembly Lower Latch AssemblyGas Valve Convection AssemblyOven Door Hinge RegulatorOven Racks Oven Cavity Components GasRack Positions Appendix a Maytag Double Oven Gas Range Double Oven Gas Range Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Appendix B Pilotless Ignition Suggested Heat SettingsOperating During a Power Failure Surface ControlsTo prevent the cooktop from discoloring or staining Surface CookingTo set the Clock To change the clock to 24-hour formatLocking the Control Oven Doors TimerFault Codes Adjusting the Sound LevelTo set bake Return To Factory Default SettingsSetting Upper and Lower Oven Functions Baking Cook & HoldDelay Cook & Hold Keep Warm Adjusting the Oven TemperatureTo cancel Keep Warm To adjust the oven temperatureTo set Broil Broiling upper oven onlyOven Bottom Automatic Shut-Off/Sabbath ModeOven Vent Oven LightsTo replace oven racks Upper ovenLower oven To remove oven racksSurface Cooking Surface Cooking Using the Touchpads Control PanelClock Adjusting Sound Level Setting Oven Functions Baking with ConvectionTo set Convect Bake To set Convect Roast Roasting With ConvectionBroiling upper oven only Broiling Chart Broil times are based on a 5 minute preheatOven Cooking To cancel a Favorite cycle in progress FavoriteTo start a cycle programmed into Favorite Sabbath Mode Notes Rack Positions lower oven Care & Cleaning Do not USE ANY Cleaning Product Containing Chlorine Bleach Appendix C LP Conversion Instructions LP Conversion Instructions LP Conversion Instructions LP Conversion Instructions