Henny Penny OFE/OFG-322 manual Power Switch, To avoid electrical shock or property damage, move

Model OFE/OFG-321,322,323,324

2-5. POWER SWITCH

(Continued)4. With control panel removed, and the wires off the switch, push in on tabs on the switch to remove from panel.

5.Replace with new switch, and reconnect wires to switch.

6.Replace the control panel.

2-6. TEMPERATURE PROBE The temperature probe relays the actual shortening temperature to

REPLACEMENT the control board. If it becomes disabled, “E-6B” will show in the display. Also, if the shortening temperature is out of calibration by more than 10°F or C°, the temperature probe should be replaced.

An Ohm check can be performed also. See chart on page 2-7.

1. Remove electrical power supplied to the fryer.

2.Drain the shortening from the frypot.

3.Remove the control panel.

Gas

4.Using a 1/2" wrench, remove the nut on the compression fitting.

5.Remove the temperature probe from the frypot.

6.Follow the appropriate instructions, on the following page, depending upon the type of fryer, gas or electric.