Henny Penny BFR/BCR-350, BCC/BCR-140 manual Duration of time the temperatures, in 9, 3ºC 37ºF

Henny PennyModel BCC/BCR-140, BCC/BCR-175, BFR/BCR-350

3-7. PROGRAMMING			11.	The duration of time the temperatures, (in 9 and 10
(Continued)				above), must remain at before the alarms will sound.
				Press theAlarm button 11 times and the digital display will
	10			show the time at which the high and low temperatures (no.
				9 and 10 above) must remain at, before the alarm will
				sound.
				The factory setting is 20 minutes, but can be changed to a
				maximum setting of 60 minutes, or a minimum of 10 minutes
				by pressing the Up and Down buttons.
				This means, that the temperature must remain at a too high,
				or too low temperature for 20 minutes before an alarm will
				sound.
			12.	International Only. A Frigiprobe sensor temperature
	11
				which can turn off the compressor, in a chilling cycle,
				to prevent freezing of the product. Press the Alarm
				button 12 times and the digital display will show the tem-
				perature, at which a sensor in the Frigiprobe will turn off the
				compressor during a Frigiprobe mode. This will prevent the
				outer surfaces of the product from freezing, however the
				cooling time will be greatly increased.
				The factory setting is 39ºF (4ºC), but can be changed to a
				maximum setting of 122ºF (50ºC), or a minimum of 32ºF
				(0ºC) by pressing the Up and Down buttons.
				NOTE
				Do not change this setting lower than the setting used in param-
				eter 22, (next page).
				NOTE
				This function will only activate when the factory setting is
				changed to above 40ºF (4ºC). England must have a setting
				of 3ºC (37ºF).
			13.	Re-initialize the controls to factory settings. Press the
		12
				Alarm button 13 times and the digital display will show
				“dEF”, at which time the Up button is pressed and the unit
				will shut down. Re-initialization is now complete.

NOTE

After re-initialization, the controls will default back to factory settings. The temperature will be in Celsius and the values in steps 12, 16, and 18, of this section, will need to checked to be accurate for the country in which the unit is installed.

300 3-12