Henny Penny BCC/BCR-175, BCC/BCR-140 manual Electrical, BCC-140, BCC-175, BFR and BCR-350

Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350

2-2. UNPACKING	4.	Open door and remove packing from the inside of the unit.
(Continued)	5.	Peel off any protective covering from the exterior of the
		cabinet.
	6.	Your Blast Chiller is now ready for operation.

If the blast chiller has been laid on its side, the unit must be sitting upright for at least an hour before applying power to the unit. Check all components for signs of being loose or damaged, and make sure the system has refrigerant. Failure to follow these instructions may causedamage to the components. Failure to follow these instructions could cause damage to the compressor.

		NOTE
	Be certain to save any literature that is packed inside the
	cabinet, or separate boxes.
2-3. ELECTRICAL	BCC-140	• 200 V, 50-60 Hz, 3 phase
		• 208-240 V, 60 Hz, 3 phase
		• 230 V, 50 Hz., 1 phase
	BCC-175	• 200 V, 50-60 Hz, 3 phase
		• 208-240 V, 60 Hz, 3 phase
		• 400 V, 50 Hz., 3N phase
	BCR-140 and 175	• 208-240 V, 60 Hz, single phase
		• 230 V, 50 Hz, single phase
		• 200 V, 50-60 Hz., single phase
	BFR and BCR-350	• 200 V, 50-60 Hz, 3 phase
		• 208-240 V, 60 Hz, 3 phase
		• 400 V, 50 Hz., 3N phase

The data plate, located inside of the unit, will specify the correct electrical supply. The unit requires a grounded receptacle with a separate electrical line protected by a fuse or circuit breaker of the proper rating.

The cabinet must be adequately and safely grounded according to local electrical codes to prevent the possibil- ity of electrical shock.

2-2 201