Henny Penny BCC/BCR-175, BCC/BCR-140, BFR/BCR-350 manual De-Icing

Page 17

Henny Penny

Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350

3-4. DE-ICING	Henny Penny recommends to perform the de-icing process after
	every 3 cycles, and at the end of each day. This will eliminate any
	ice that may have formed around the evaporator during the chilling
	cycle. Failure the follow this procedure will increase the time it
	takes to cool the product and may lead to unsafe product.
	1.	Remove all product from the unit.
	2.	Close the door.
	3.	Press the ON/OFF button to turn the unit on.
	4.	Press the De-ice button. The digital display will now show
		“d. 01”. The compressor will not come on, but the evapo-
		rator fan will come on and pull warm air across the evaporator,
		created by the de-icing elements.
	5.	Allow the de-ice cycle to run for a minimum of 10 minutes
		and a maximum of 25 minutes. The unit will automatically

turn off when the evaporator has been de-iced, and reached a temperature of 77ºF (25ºC).

NOTE

If the above procedures does not remove all the ice from the evaporator, the length of time, and the temperature at which the de-ice cycle turns the unit off, can be adjusted. See the Programming section.

3-7

100

Image 17

Contents Page Henny Penny Blast Chiller/Freezer Limited Warranty for Henny Penny Appliances Table Ofcontents Blast Chiller FeaturesProper Care AssistanceSafety Unpacking IntroductionBCC-140 ElectricalBCC-175 BCR-140BFR LocationRefrigeration Refrigerant InformationCapacities BFR-350Description Function Operating ControlsOn BFR units Only applicableHenny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 100 Start-up Basic OperationBasic Operation Convenience Temperature conversion chart is provided for yourDE-ICING Monthly BCC-140 Only CleaningDaily Seasonal or Prolonged Shutdown CleaningNot Available at this time ProgrammingMaximum duration of de-icing cycle minutes. Press Above, must remain at before the alarms will sound Duration of time the temperatures, in 9International Only. a Frigiprobe sensor temperature To prevent freezing of the product. Press the AlarmFrigiprobe, in of this section. Press the Alarm Blast chilling, low side air temperature limit, when usingBlast chilling, high side air temperature limit, when using Frigiprobe, end of cycle temperature setting. PressStart of a cycle. Press the Alarm button 17 times, Frigiprobe temperature for when the buzzer sounds atTemperature that the buzzer will sound when the product Has reached the danger zone temperature, and must beDisplay Cause Correction TroubleshootingProblem Cause Correction TroubleshootingAlarms 100 Troubleshooting Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 100 Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 201 Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 201 Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 201 Description 140 175 350 QuantityBCC BCR Part Page CPE-USALCO Page Henny Penny International Distributor Network Oman