Manitowoc Ice manual Single

Installation Instructions Section 2

Remote Electrical Wiring Connections

!Warning

These diagrams are not intended to show proper wire routing, wire sizing, disconnects, etc., only the correct wire connections.

All electrical work, including wire routing and grounding, must conform to local, state and national electrical codes.

Though wire nuts are shown in the drawings, the ice machine field wiring connections may use either wire nuts or screw terminals.

Important

F2 wire is located in the compressor compartment behind the control box. The wire is labeled F2 and capped with a wire nut.

REMOTE ICE MACHINE

WITH SINGLE CIRCUIT MODEL CONDENSER 115/1/60 OR 208-230/1/60

SINGLE	L1
CIRCUIT	L2	NOTE:
REMOTE		CONDENSER FAN
CONDENSER		MOTOR VOLTAGE
	GROUND	MATCHES ICE
		MACHINE
		VOLTAGE (115V
		OR 208-230V)
	F2
	F1
ICE	L1		L1
MACHINE
	L2	N=115V OR L2=208-230V	L2

	GROUND	GROUND
		TO SEPARATE
SV1255		FUSE/BREAKER

REMOTE ICE MACHINE

WITH SINGLE CIRCUIT MODEL CONDENSER 208-230/3/60 OR 380-415/3/50

SINGLE	L1
CIRCUIT		NOTE: FAN
REMOTE	L2
CONDENSER		MOTOR IS
		208-230V

GROUND

F2
F1
ICE
MACHINE L1		L1
L2		L2
L3		L3
	GROUND	GROUND

TO SEPARATE

FUSE/BREAKER

SV1199

REMOTE ICE MACHINE

WITH SINGLE CIRCUIT MODEL CONDENSER 230/1/50

SINGLE CIRCUIT	L1
REMOTE		NOTE: FAN
CONDENSER L2
		MOTOR IS
		220-240V

F2
F1
ICE
MACHINE		L1
L1
N		N
	GROUND	GROUND

TO SEPARATE

FUSE/BREAKER

(220-240).

SV1256DISCONNECT ALL

POLES.

2-12 Part Number 80-1620-3