SECTION 5: SERVICE PROCEDURES
RINSE REGULATING THERMOSTAT REPLACEMENT
7.Insert the new thermostat/brass fitting combination into the well and tighten down the brass fitting by hand.
Tightening the brass fitting.
8.Use the 7/16” combination wrench to tighten down the brass fitting, while also positioning the new thermostat so that it does not hang over the heater.
What the installed thermostat should look like (Tempstar).
9.Note: regardless of the unit this is being done to, the con- cept is to ensure that the thermostat cannot come into contact with the heater leads or interfere with the placement of any covers.
Removing the thermostat screws.
10.Use the phillipshead screwdriver to remove the attach- ment screws on the thermostat for the NORMALLY CLOSED and COMMON points.
Fitting the jumper into the mounting cup.
11.Attach the ring ends of the jumpers to the cups/screws removed from the thermostat and attach them. The white jumper is to be connected to COMMON. The orange and white jumper is to be connected to NORMALLY CLOSED. Refer to your machine schematic if you have any questions regarding this.
Securing jumpers to the thermostat.
200 Series Technical Manual
25