Setting, Starting cooking, Oven OFF | Fisher & Paykel OR30SDPWGX

switch the oven off automatically after the programmed cooking time

TIMER

The timer function is only used to count the time and does not inﬂuence oven opera- tion or any programmes which are in progress or set.

1.Press - “0:00” appears on the programmer display.

2.Press or to set the time required (or turn the temperature dial to the right to increase the time and to the left to reduce it) - the bell symbol lights up on the display.

3.The countdown starts immediately and the time appears again.

4.To see the countdown press . The time will be indicated in hours and minutes; the seconds are only indicated for the last minute.

5.At the end of the countdown an audible signal sounds and the bell symbol goes out. Press any button to stop the audible signal.

IMPORTANT WARNING: This function is only an electronic alarm and does not

switch OFF the oven. Remember to turn to OFF (oven OFF) manually the se- lector dial at the end of the countdown.

AUTOMATIC COOKING - Start cooking at the programmed time and switch the oven off automatically after the programmed cooking time

OR SEMI-AUTOMATIC COOKING - Start immediate cooking and

switch the oven off automatically after the programmed cooking time

Setting

1.Set the cooking function by turning the oven selector to the function required.

2.The pre-set cooking temperature appears on the display. To change it proceed as described in the “USING THE OVEN” chapter.

3.Press of the programmer to conﬁrm the cooking function.

4.Press : “0:00” appears on the electronic programmer display.

Press or to set the cooking time or turn the temperature dial to the right to increase the time and to the left to reduce it (cooking time in hours and minu- tes: set it to ten minutes less than the time required because the stored heat will complete the cooking). “A” appears on the display.

5.Press ; then press or to set the time when the cooking should ﬁnish or turn the temperature dial to the right to increase the time and to the left to reduce it.

6.The display reads the set temperature.

Semi-automatic cooking: If you are already at home to turn the oven on and only want the oven to turn off automatically, start cooking as normal, then fol- low step 4 or step 5 to set the cooking time or a time to stop the oven.

Starting cooking

7.The cooking symbol lights up. The oven switches on and the cooking cycle set starts.

During cooking

8.During the cooking cycle, the display shows the oven temperature measured by

the probe or pre-set temperature. Press to display the length of cooking set. Press to display the stop time set. The cooking time, end of cooking time and cooking temperature can be varied at any time, as described above.

At the end of cooking

9.“End” appears on the display, “A” ﬂashes and the audible signal sounds. The cooking cycle has ﬁnished and the oven is OFF. Press any programmer button to stop the audible signal.

10.Turn the function selector to OFF (oven OFF). The programmer display shows the time.

Note: At the end of the program always turn the function selector dial to OFF

(oven OFF).

IMPORTANT: During AUTOMATIC COOKING PROGRAM the oven light is always on, also before starting (heating elements on or cycling) of the programmed cooking.

OFF

AOFF

OFF

		I	I I
IA I
I	I		I
I			I
I		I	I
		I