Recommendations and | To | program | a | cooking | time of less than 10 minutes, always press 0 befor | |
warnings | the | required | value. | Any | cooking time can be programmed up to 99 minute | |
| loss | in power, | the | time | programming function will no longer be activated. | |
The timer
It is programmed as follows
Once the time has elapsed
Correcting the time
Switching the timer off
Recommendations and warnings
This can be used to time periods up to 99 minutes. It is independent of settings.
1.Press theTIMER symbol.00 appears in the time programming function display. Themin andQ indicators light up.
2.Program the time using symbols 0 to 9.
The timer starts to count down after a few seconds.
A beep sounds. The00 andmin | and Q indicators blink on the time program | |||
function display. Press | theTIMER symbol. The indicators and the warning sou | |||
signal go out. |
|
|
|
|
Press theTIMER symbol until | themin | indicator | lights up and change the time | |
the 0 to 9 symbols | or with | the | + and - | symbols. |
Press theTIMER symbol until themin indicator lights up and then press0 or thethe
-symbol until 00 on the time programming function display. The timer will be deactivated after a power outage.
The element automatic OFF function and the timer function can both be op simultaneously.
Automatic time limitation
The automatic time limitation function is activated if the element is used for prolonged periods without any modifications being made.
The element stops heatingr, .i and the residual heat warningt/slightflash alternately on the element display.
The indicator goes out when any symbol is pressed. The element can now
When the automatic time limitation function is activated, this is controlled by selected heat setting (from 1 to 10 hours).
22