iTechnical Assistance Service
Troubleshooting
The cooktop is not working
The indicator light on the element is flashingE
E flashes on all the element displays and a signal sounds
The cooktop turns off by itself
Sometimes problems are unimportant technical problems that can be easily resolved. Before contacting Technical Assistance, please keep in mind the advic and warnings below:
See if there is a power outage. Check to see if there | is a | problem | with | the | |||
breaker for the electrical installation. |
|
|
|
|
|
| |
The touch key panel | is heavily soiled, food has boiled | over, | or | there | is somet | ||
lying on the touch key. Wipe the touch key thoroughly | or remove the object f | ||||||
cooktop. Lightly press the corresponding touch key. The | flashing | should | stop. | ||||
The main switch has | been activated continuously for more than | 5 | seconds. | Wi | |||
any soil on the touch | keys or remove any objects that | are | resting | on | the | coo | |
Reset the cooktop. |
|
|
|
|
|
|
|
The power key was touched unintentionally. Press the power key again. Reset cooktop.
The display flashes (there is no | Check to see whether the | saucepan is | ferromagnetic. | Check to see whether th | ||||
power) | when you | place a saucepan | diameter of | the saucepan | is large | enough. Allow the | saucepan to cool down i | |
on an | induction | element | event that it | has become | too hot | when | used. |
|
|
|
|
|
The Powerboost function display flashes and then switches off
If the display still does not light up when you switch the element off and on disconnect the appliance at the circuit breaker. Wait 20 seconds and then reconnect it.
The powerboost function operates the element with the most possible power. During long cooking times, it is possible that the function will switch the eleme to protect the cooktop from overheating. You can continue to use the cooktop display is not flashing.
Repairs |
| WARNING: | Repairs should | only | be | one | by | a | trained | servicer. | ||||
|
|
|
|
|
|
|
|
| d | could be at considerable risk. | ||||
|
| If your appliance is repaired improperly, you | ||||||||||||
Display E Ö and | numbers | If anE Ö | and | a series | of numbers | appear | in | the | display panel, there is a fault | |||||
|
| electronic | system. Turn | the | appliance | off | and | back | on at | the fuse or circuit b | ||||
|
| Call technical assistance if the same display appears again. | ||||||||||||
Display F and | numbers | If anF and | a number | flash | in | alternation | on | the | displays, | your appliance has | ||||
|
| detected | a | fault. Refer | to the | following table | for | possible | remedies. |
27