GE 197D3351P003 HOW to Connect Electricity, Troubleshooting Tips, Consumer Support

Page 4

Safety Instructions

IMPORTANT SAFETY INFORMATION.

READ ALL INSTRUCTIONS BEFORE USING.

WARNING!

HOW TO CONNECT ELECTRICITY

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. For personal safety, this appliance must be properly grounded.

Instructions Operating Instructions

The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall outlet to minimize the possibility of electric shock hazard from this appliance.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.

If the outlet is a standard 2-prong outlet, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.

The refrigerator should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating plate.

This provides the best performance and also prevents overloading house wiring circuits which could cause a fire hazard from overheated wires.

Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet.

Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.

When moving the refrigerator away from the wall, be careful not to roll over or damage the power cord.

Installation

USE OF ADAPTER PLUGS (Adapter plugs not permitted in Canada)

Because of potential safety hazards under certain conditions, we strongly recommend against the use of an adapter plug.

Troubleshooting Tips

However, if you must use an adapter, where local codes permit, a temporary connection may be made to a properly grounded 2-prong wall outlet by use of a UL-listed adapter available at most local hardware stores.

The larger slot in the adapter must be aligned with the larger slot in the wall outlet to provide proper polarity in the connection of the power cord.

When disconnecting the power cord from the adapter, always hold the adapter in place with one hand while pulling the power cord plug with the other hand. If this is not done, the adapter ground terminal is very likely to break with repeated use.

If the adapter ground terminal breaks, DO NOT USE the refrigerator until a proper ground has been established.

Attaching the adapter ground terminal to a wall outlet cover screw does not ground the appliance unless the cover screw is metal, and not insulated, and the wall outlet is grounded through the house wiring. You should have the circuit checked by a qualified electrician to make sure the outlet is properly grounded.

Consumer Support

READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.

SAVE THESE INSTRUCTIONS

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents GEAppliances.com Write your model and serial numbers here Model # Serial #Safety Precautions Proper Disposal of the Refrigerator USE of Extension CordsBefore You Throw Away Your Old Refrigerator or Freezer CFC DisposalTroubleshooting Tips HOW to Connect ElectricityConsumer Support About the controls on the refrigerator FreezerAbout the shelves and bins About the water filter cartridgeInstructions Support Rearranging the ShelvesSpillproof Shelves on some models Quick Space Shelf on some modelsAbout the additional features About the crispers and pansAbout crisper removal SafetyAbout the automatic icemaker About the ice and water dispenser To Use the DispenserLocking the Dispenser on some models Dispenser LightCare and cleaning of the refrigerator Cleaning the OutsideCleaning the Inside Tips Consumer SupportPreparing for Vacation Behind the RefrigeratorPreparing to Move Troubleshooting Tips Consumer Support Replacing the lightbulbsClearances Refrigerator LocationRollers Installation Instructions Door AlignmentBefore YOU Begin What YOU will NeedChoose the Valve Location Shut OFF the Main Water SupplyDrill the Hole for the Valve Fasten the Shutoff Valve Tighten the Pipe ClampRoute the Tubing Connect the Tubing to ValveConnect the Tubing to the Refrigerator Turn the Water on AT the Shutoff ValvePlug in the Refrigerator Start the IcemakerSafety Instructions Troubleshooting Tips Customer ServiceProblem Possible Causes What To Do Before you call for service…Normal operating sounds See Installing the water line See Care and cleaningSee About the controls Fresh food or freezerWater in first glass is Water dispenser doesWater spurting from DispenserHot air from bottom RefrigeratorBut Crushed ICE was Staple your receipt hereConsumer Support Troubleshooting Tips GE Will ReplaceWhat GE Will Not Cover Warrantor General Electric Company. Louisville, KYOperating Specifications General Installation/Operation/Maintenance RequirementsHealth Claim Performance Certified by NSF/ANSI Special NoticesWater Treatment Device Certificate Number General Electric Company Consumer Product Ownership Registration Mesures de sécurité Fonctionnement Installation Mesures de sécuritéService à la clientèle Conseils de dépannage Fonctionnement InstallationMesures DE Sécurité Cordons Prolongateurs Se débarrasser du CFCRaccordement Électrique Conseils de dépannageLes commandes Mesures de sécuritéInstallation Clientèle Conseils de dépannage Service à laLa cartouche du filtre à eau Clayettes et bacsLa clientèle Réarrangement des clayettesClayette coulissante anti-déversement sur certaines modèles Clayettes anti-débordements sur certaines modèlesInstallation Conseils de dépannage Service à la clientèleClayettes et bacs Bacs à légumesEnlèvement du bacs à légumes Machine à glaçons automatiqueMesures De sécuritéLe distributeur d’eau et de glaçons SécuritéDe dépannage Pour utiliser le distributeurEntretien et nettoyage du réfrigérateur Nettoyage de l’extérieurNettoyage de l’intérieur CondensateurInstallation Service à la clientèle Conseils de dépannage Derrière le réfrigérateurDépart en vacances DéménagementCompartiment congélateur Compartiment des aliments frais-Éclairage supérieurDistributeur Emplacement DU Réfrigérateur Alimentation D’EAU À LA Machine À GlaçonsDégagements Roulettes DE NivellementInstructions d’installation Alignement DES PortesAvant DE Commencer Avant DE Commencer SuiteCE Dont Vous Aurez Besoin SuitePercez UN Trou Pour LE Robinet Fixez LE Robinet D’ARRÊTSerrez LE Collier DE Serrage Acheminez LE TuyauPurgez LE Tuyau Branchez LE Tuyau AU RobinetBranchez LE Tuyau À Votre Réfrigérateur Branchez Votre Réfrigérateur Fermez L’EAU AU Niveau DU Robinet D’ARRÊTMettez EN Marche LA Machine À Glaçons Mesures de sécurité Fonctionnement Installation Bruits de fonctionnement normaux Avant d’appeler un réparateur…Problème Causes possibles Correctifs Le réfrigérateur neProblème Causes possibles Correctifs Mesures de sécurité Fonctionnement Consultez Remplacement des ampoules De la condensationPar temps humide ’ouverture des portesFonctionnement Agraphez votre reçu iciSpécifications d’opération Exigences générales d’installation/opération/entretienAvis spéciaux Service de réparations Service à la clientèleProlongation de garantie Seguridad Operación Instalación Información de seguridadPrecauciones DE Seguridad Servicio al consumidor Solucionar problemasOperación Instalación Antes de deshacerse de su viejo refrigerador o congelador USO DE Cables DE ExtensionDeshacerse del CFC Como Conectar LA Electricidad Solucionar problemasInstalación Los controles del refrigerador SeguridadEl cartucho del filtro de agua Instalación Solucionar problemasLos entrepaños y recipientes del refrigerador Al consumidor Reubicación de los entrepañosEntrepaños a prueba de derrames en algunos modelos Entrepaño QuickSpace en algunos modelosCaracterísticas adicionales Sobre las gavetas de almacenamientoEl dispositivo automático para hacer hielo Como sacar la gaveta preservadora de alimentosGaveta de almacenamiento de hielo Kit accesorio para hielosEl dispensador de agua y de hielo ProblemasServicio al consumidor Solucionar Cuidado y limpieza del refrigerador Limpiar el exteriorLimpiar el interior CondensadorInstalación Servicio al consumidor Solucionar problemas Atrás del refrigeradorPreparación para vacaciones En caso de mudanzaReemplazo de bombillas Compartimento de alímentos frescos-Luz superiorCompartimiento del congelador DispensadorEspacios Libres Ubicación DEL RefrigeradorRodillos Instrucciones para Instalación Alineación DE LAS PuertasAntes DE Iniciar QUÉ NecesitaPerfore EL Orificio Para LA Válvula BienInstale LA Válvula DE Cierre Apriete LA Abrazadera DEL TuboDirija LA Tubería Conecte LA Tubería a LA VálvulaConecte LA Tubería AL Refrigerador NotasConecte EL Refrigerador Inicie LA Máquina DE HielosNotas Problema Causas Posibles Qué hacer Sonidos normales de la operaciónAntes de solicitar un servicio… Dispositivo para hacer hielo en algunos modelosVea Los controles Compartimiento deAlimentos frescos o Congelador demasiadoLa puerta no se cierre CorrectamenteBrillo anaranjado En el congeladorNo sale agua y el Hielo no funcionaEl refrigerador huele Del refrigeradorSeguridad Operación Durante GE reemplazaráLo que GE no cubrirá Garantidor General Electric Company. Louisville, KYEspecificaciones de Operación Avisos EspecialesNotas Ayuda al Cliente Página Web de GE Appliances Solicite una reparaciónGarantías ampliadas Piezas y accesoriosGE Appliances Website Schedule Service Consumer Support

197D3351P003 specifications

The GE 197D3351P003 is a highly regarded component in the realm of electronic systems, particularly used in the aviation and aerospace industries. This product is a vital part of the engine control units (ECUs) that manage various critical functions of modern aircraft engines. Its design reflects advanced engineering principles aimed at ensuring reliability, efficiency, and adaptability.

One of the primary features of the GE 197D3351P003 is its exceptional durability. Built to withstand extreme environmental conditions, this component operates effectively in a wide range of temperatures, pressures, and vibrations. The rugged construction is essential for maintaining performance and safety in demanding aviation scenarios.

The technology incorporated in the GE 197D3351P003 is at the forefront of innovation. It uses advanced algorithms to process data quickly and accurately, allowing for real-time monitoring and control of engine parameters. This enables the engine to operate within optimal performance bounds, enhancing fuel efficiency and reducing emissions. The integration of modern software also means that updates and improvements can be implemented swiftly, keeping the system current with the latest advancements in aviation technology.

Another significant characteristic of this component is its modular design. This feature allows for easy integration into existing systems and facilitates maintenance and upgrades, which are crucial for managing the lifecycle of aircraft. The modularity also contributes to reducing downtime during servicing operations, a vital consideration in aviation where time is of the essence.

Furthermore, the GE 197D3351P003 is built with redundancy in mind. In aviation environments, the failure of any single component can have serious consequences. Therefore, this part incorporates multiple layers of backup systems to ensure continuous operation, even in the event of a malfunction. This focus on redundancy enhances the overall reliability of the aircraft, giving operators peace of mind.

In summary, the GE 197D3351P003 stands out due to its durability, advanced technology, modular design, and built-in redundancy. These features make it an essential component for contemporary aviation systems, contributing to safer, more efficient, and environmentally friendly aircraft operations. As technologies continue to evolve, the role of components like the GE 197D3351P003 will be critical in shaping the future of aerospace engineering.
Top Page Image Contents