LG Electronics LRG30855ST, LRG30355ST, LRG30355SW, LRG30355SB manual Using the Clock and Timer

O P E R AT I N G I N S T RU C T I O N S

USING THE CLOCK AND TIMER

HOW TO SET THE CLOCK

The clock must be set to the correct time

of day for the automatic oven timing functions to work properly. The time of day cannot

be changed during a timed baking or self-cleaning cycle.

1 Touch the CLOCK pad once to set.

2 Touch the number pads to enter the time. Touch the number pads the same way you read them. For example, to set 12:34, touch the number pads 1, 2, 3, and 4 in that order.

If number pads are not touched within one minute after you touch the CLOCK pad, the display reverts to the original setting. If this happens, touch the CLOCK pad and reenter the time of day.

3 Touch the START pad until the time of day shows in the display. This enters the time and starts the clock.

To check the time of day when the display is showing other information, simply touch the CLOCK pad.

HOW TO SET THE TIMER

The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.

1 Touch the TIMER ON/OFF pad.

2 Touch the number pads until the amount of time you want shows in the display. The maximum time that can be entered in minutes is

59.Times more than 59 minutes should be changed to hours and minutes. For example, to enter 90 minutes as 1 hour 30 minutes, touch 1, 3, and 0 in that order.

NOTE: If you make a mistake, press the TIMER ON/OFF pad and begin again.

3 Touch the START pad. After pressing the START pad, SET disappears; this tells you the time is counting down, although the display does not change until one minute has passed.

4 When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the TIMER ON/OFF pad is touched.

The 6 second tone can be canceled by following the steps in the Special Features of Your Oven Control section under Tones at the End of a Timed Cycle.

NOTE: The timer is a minute timer only. The CLEAR/OFF pad does not affect the timer.

HOW TO RESET THE TIMER

If the display is still showing the time remaining, you may change it by touching the TIMER ON/OFF pad, then touch the number pads until the time you want appears in the display.

If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by touching the TIMER ON/OFF pad and then touching the number pads to enter the new time you want.

HOW TO CANCEL THE TIMER

Touch the TIMER ON/OFF pad twice.

POWER OUTAGE

If a flashing time is in the display, you have experienced a power failure. Reset the clock.

Touch the CLOCK pad once to reset. Enter the correct time of day by touching the appropriate number pads. Touch the START pad.

17