PREPARING THE SYSTEM FOR INSTALLATION
5000
/ 5000
Single Piece Mounting Bracket
The 5000ti/tiR utilizes a single piece mounting bracket, this sturdy bracket frames the in- stallation location and secures the unit to the wall. WhisperKOOL has also designed the bracket to hold the system at a 2º degree angle, this helps project the air into the space and aids in condensation drainage.
Applying Insulation Tape
Locate the (4) precut pieces of black foam tape included with the system, two larger pieces and two smaller pieces. To apply, simply peel back the
Mounting Bracket Installation
Select your desired bracket mounting location (see diagram below), this location determines the depth of the instal- lation. For example, position #1 keeps most of the system out of the cellar while position #4 makes the back of the system near flush on the exterior wall. Slide bracket onto unit, pay special attention to the TOP label on the bracket and the flanges for mounting to the unit are towards the back. Use the (4) supplied 1/2” self tapping screws to fasten the bracket to the unit. It is imperative to not use self tapping screws longer than 1/2” in length.
If you are installing through an exterior wall, please review page 18 for
specific instructions on exterior grill installation.
5” inch thick wall 
(wall thickness may vary)
Wine Cellar
Mounting Bracket
Exhaust Area
| #1 | |
| ||
|
|
|
#2
#3
#4
Page 16 | EXti 110111 |