WhisperKool 5000 owner manual Standard Controller Layout

Page 8

QUICK REFERENCE GUIDE

Standard Controller Layout

*If your unit is installed through the wall and does not have a remote keypad you have the Standard Controller*

Note: The 1 or 3-5 qualifies the amount of time in seconds that the button must be pushed to activate the feature.

Refer to page 30 for complete listing of buttons and symbols.

Energy Saving

Button 1

Energy Reduction

Set Button

•View Set Point 1

•Change Set Point 3-5

Anti Frost

Compressor Evaporator and Condenser Fan

Cellar “Pre-Chill” Button 3-5

Hi Bottle Temp History & Scroll

Button 1

Push to see the max stored temperature. In programming mode use to browse the parameter codes or increase the display value. Hold for 3 seconds to start fast freezing cycle.

•SET + Down = CPSM 10-15

•Reset Hi & Lo Button 3-5

Display and modify set point. In programming mode it selects a parameter con￿rms an opera- tion. Hold for 3 seconds when the min or max temperature is displayed to RESET.

ALARM

Pre-Chill Display

Control “ON/OFF” Button

•Turns the Cooling Unit

“ON/OFF”

Low Bottle Temp History & Scroll Button 1

Push to see the min. stored temperature. In programming mode use to browse the parameter codes or decrease

the displayed value1 .

Remote Controller Layout

*If your unit has a remote keypad then you have the Remote Controller*

Note: The 1 or 3-5 qualifies the amount of time in seconds that the button must be pushed to activate the feature.

Refer to page 34 for complete listing of buttons and symbols.

Inactive

Set Button

•View Set Point 1

•Change Set Point 3-5

•SET + Down = CPSM 3 - 5

Anti Frost Compressor Evaporator and Condenser Fan

Hi Bottle Temp History & Scroll

Button 1

Cellar “Pre-Chill” Button 3-5

Push to see the max stored temperature. In programming mode use to browse the parameter codes or increase the display value. Hold for 3 seconds to start fast freezing cycle.

•Reset Hi & Lo Button 3-5

Display and modify set point. In programming mode it selects a parameter con￿rms an opera- tion. Hold for 3 seconds when the min or max temperature is displayed to RESET.

ALARM

Pre-Chill Display

Low Bottle Temp History & Scroll Button 1

Push to see the min. stored temperature. In programming mode use to browse the parameter codes or decrease

the displayed value1 .

Control “ON/OFF” Button

•Turns the Cooling Unit

“ON/OFF”

Page 6

EXti 110111

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Extreme 5000 Page Table of Contents Quick Reference Guide Front / Side ViewFully Ducted Front / Side View 8000 / 8000 Rear / Side View Compressor Access Panel Standard Controller Layout Unit Specifications FAN Speed ReferenceModel Low Med HighIntroduction Review the Packing Slip to Verify Contents Check the Box for the following contents 5000Receiving & Inspecting the Unit Receiving and Inspecting the UnitQuick Start Guide Vapor Barrier Preparing the Wine CellarInsulation Door and Door Seal Mounting the UnitUnobstructed Airflow Air Intake Cellar Wall Ambient Temperature Factor Using any other ducting system will void the warrantyVentilation Exhaust FanElectrical Inlets PRE-INSTALLATIONElectrical Needs Preparing the Installation Location Minimum Tools NeededPreparing the System for Installation Mounting Bracket InstallationSingle Piece Mounting Bracket Applying Insulation Tape8000 Mounting FlangesExterior Grille Installation Non-Flush InstallationFlush Installation Optional Exterior Grille8000 Back of Unit THROUGH-THE-WALL InstallationInstalling the System Ducting Overview Use of DuctworkGeneral Duct Recommendations Location of Supply and Return GrillesDucting Configurations Half Duct Configuration Wine CellarThree-Quarter Duct Configuration Wine Cellar Adjacent RoomFully Ducted Attic Mounted SystemInstalling the Duct Plenums Remote Controller Installation Mounting Bracket Failure to install the drain line voids the warranty Drain LineCondensation Drain Line Tube Drain LineLiquid Measuring Thermostat System Self-Calibrating ProbeLiquid Measuring Thermostat System To Use the thermostat57/57 Multi FAN Speed Control59/59 60/61 System Operation Button/Symbol Normal Functions Standard Controller FunctionsUp and Down ArrowsAlarm Anti-FrostPage Standard Remote Controller Functions Button Normal FunctionsCheck Evaporator Probe connection at green terminal block on Cpsm Mode Remote Wire Schematic Maintenance Schedule Unit does not run/power up Possible Cause Solution Cellar Temperature is to Warm Possible Cause SolutionUnit leaks water Possible Cause Solution Unit runs but does not cool Possible Cause SolutionPossible Cause Solution Compressor short cycles Possible Cause SolutionAccessories for Cooling Units Contact WhisperKOOL Customer ServiceTechnical Assistance Condensate Pump KitInstallation Terms and Conditions WhisperKOOL Cooling SystemProduct Installation Requirements Model Serial NumberA Installed by Date Sales and USE TAXPage Page WhisperKOOL
Top Page Image Contents