WhisperKool 5000 owner manual Condensation Drain Line Tube

Page 29

DRAIN LINE

Condensation Drain Line Tube

The condensation drain line tube is used to remove excess condensation from the unit to a proper discharge location. It is important that the drain line tube is properly connected and used to prevent leakage and other problems associ- ated with excess condensation.

Failure to use the condensation drain line tube will void the warranty on the unit.

Drain Line

All units come with a drain line for additional removal of excessive condensate. It is mandatory to install the drain line with “T” fitting. During operation, the cooling unit will strip excess water from the air in order to maintain the proper level of humidity within the cellar. However in extreme humidity, additional condensate will be removed. Thus the drain line will prevent overflow and leak- ing by allowing for discharge of the additional condensate.

Drain Line

T-Fitting

Failure to install the drain line voids the warranty.

To prevent mold from growing, allow the drain line to hang above the water line.

WRONG: Drain line is under water.

Page 27

Image 29
Contents Extreme 5000 Page Table of Contents Front / Side View Quick Reference GuideFully Ducted Front / Side View 8000 / 8000 Rear / Side View Compressor Access Panel Standard Controller Layout FAN Speed Reference Unit SpecificationsModel Low Med HighIntroduction Check the Box for the following contents 5000 Review the Packing Slip to Verify ContentsReceiving & Inspecting the Unit Receiving and Inspecting the UnitQuick Start Guide Vapor Barrier Preparing the Wine CellarInsulation Door and Door Seal Mounting the UnitUnobstructed Airflow Using any other ducting system will void the warranty Air Intake Cellar Wall Ambient Temperature FactorVentilation Exhaust FanElectrical Inlets PRE-INSTALLATIONElectrical Needs Minimum Tools Needed Preparing the Installation LocationMounting Bracket Installation Preparing the System for InstallationSingle Piece Mounting Bracket Applying Insulation TapeMounting Flanges 8000Non-Flush Installation Exterior Grille InstallationFlush Installation Optional Exterior Grille8000 Back of Unit THROUGH-THE-WALL InstallationInstalling the System Use of Ductwork Ducting OverviewGeneral Duct Recommendations Location of Supply and Return GrillesHalf Duct Configuration Wine Cellar Ducting ConfigurationsThree-Quarter Duct Configuration Wine Cellar Adjacent RoomAttic Mounted System Fully DuctedInstalling the Duct Plenums Remote Controller Installation Mounting Bracket Drain Line Failure to install the drain line voids the warrantyCondensation Drain Line Tube Drain LineSelf-Calibrating Probe Liquid Measuring Thermostat SystemLiquid Measuring Thermostat System To Use the thermostat57/57 Multi FAN Speed Control59/59 60/61 System Operation Standard Controller Functions Button/Symbol Normal FunctionsUp and Down ArrowsAnti-Frost AlarmPage Standard Button Normal Functions Remote Controller FunctionsCheck Evaporator Probe connection at green terminal block on Cpsm Mode  Remote Wire SchematicMaintenance Schedule Cellar Temperature is to Warm Possible Cause Solution Unit does not run/power up Possible Cause SolutionUnit runs but does not cool Possible Cause Solution Unit leaks water Possible Cause SolutionPossible Cause Solution Compressor short cycles Possible Cause SolutionContact WhisperKOOL Customer Service Accessories for Cooling UnitsTechnical Assistance Condensate Pump KitWhisperKOOL Cooling System Installation Terms and ConditionsProduct Installation Requirements Sales and USE TAX Model Serial NumberA Installed by DatePage Page WhisperKOOL