WhisperKool 5000 Receiving & Inspecting the Unit, Receiving and Inspecting the Unit, 8000

Page 11

RECEIVING & INSPECTING THE UNIT

Receiving and Inspecting the Unit

Lift only at the designated hand hold locations on the shipping container or fully support the unit from un- derneath. A shipment may include one or more boxes containing accessories.

Before opening the container, inspect the packaging for any obvious signs of damage or mishandling.

Write any discrepancy or visual damage on the Bill of Lading before signing.

Place the box containing the WhisperKOOL unit on a tabletop to prepare it for testing prior to installing.

Sit upright for 24 hours.

Note: WhisperKOOL Extreme units are manufactured in the USA and tested prior to shipment.

Review the Packing Slip to Verify Contents

Check the model number to ensure it is correct.

Check that all factory options ordered are listed.

If any items listed on the packing slip do not match your order information, contact WhisperKOOL Customer Service immediately.

Check the Box for the following contents:

5000 / 5000

Single Piece Mounting Bracket

Accessory Kit One:

WhisperKOOL Extreme Series Owner’s Manual Accessory Kit Two:

Power Cord

Mounting Bracket Insulation Foam 16” (2)

Mounting Bracket Insulation Foam 17” (2)

Bottle Temperature Probe (Standard Unit) Accessory Kit Three:

1 3/4 Standard Screws (9)

1/2 Self-Tapping Screws (5)

1/2 x 1/2 Barbx MNPT Fitting

Drain Line tube (1)

Connection “T” (1)

8000 / 8000

Mounting Flanges (4)

Accessory Kit One:

WhisperKOOL Extreme Series Owner’s Manual Accessory Kit Two:

Power Cord

Mounting Bracket Insulation Foam 16” (2)

Mounting Bracket Insulation Foam 22” (2)

Bottle Temperature Probe (Standard Unit) Accessory Kit Three:

1 3/4 Standard Screws (9)

1/2 Self-Tapping Screws (9)

Drain Line tube (1)

Tube Clamp (1)

Connection “T” (1)

Please leave the WhisperKOOL unit in its original box until you are ready for installation. This will allow you to move the product safely without damaging it. When you are ready to remove the product from the box, refer to page 12 for installation instructions.

TIP: Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.

Page 9

Image 11
Contents Extreme 5000 Page Table of Contents Front / Side View Quick Reference GuideFully Ducted Front / Side View 8000 / 8000 Rear / Side View Compressor Access Panel Standard Controller Layout Low Med High Unit SpecificationsFAN Speed Reference ModelIntroduction Receiving and Inspecting the Unit Review the Packing Slip to Verify ContentsCheck the Box for the following contents 5000 Receiving & Inspecting the UnitQuick Start Guide Vapor Barrier Preparing the Wine CellarInsulation Door and Door Seal Mounting the UnitUnobstructed Airflow Exhaust Fan Air Intake Cellar Wall Ambient Temperature FactorUsing any other ducting system will void the warranty VentilationElectrical Inlets PRE-INSTALLATIONElectrical Needs Minimum Tools Needed Preparing the Installation LocationApplying Insulation Tape Preparing the System for InstallationMounting Bracket Installation Single Piece Mounting BracketMounting Flanges 8000Optional Exterior Grille Exterior Grille InstallationNon-Flush Installation Flush Installation8000 Back of Unit THROUGH-THE-WALL InstallationInstalling the System Location of Supply and Return Grilles Ducting OverviewUse of Ductwork General Duct RecommendationsAdjacent Room Ducting ConfigurationsHalf Duct Configuration Wine Cellar Three-Quarter Duct Configuration Wine CellarAttic Mounted System Fully DuctedInstalling the Duct Plenums Remote Controller Installation Mounting Bracket Drain Line Failure to install the drain line voids the warrantyDrain Line Condensation Drain Line TubeTo Use the thermostat Liquid Measuring Thermostat SystemSelf-Calibrating Probe Liquid Measuring Thermostat System57/57 Multi FAN Speed Control59/59 60/61 System Operation Arrows Button/Symbol Normal FunctionsStandard Controller Functions Up and DownAnti-Frost AlarmPage Standard Button Normal Functions Remote Controller FunctionsCheck Evaporator Probe connection at green terminal block on Cpsm Mode  Remote Wire SchematicMaintenance Schedule Cellar Temperature is to Warm Possible Cause Solution Unit does not run/power up Possible Cause SolutionCompressor short cycles Possible Cause Solution Unit leaks water Possible Cause SolutionUnit runs but does not cool Possible Cause Solution Possible Cause SolutionCondensate Pump Kit Accessories for Cooling UnitsContact WhisperKOOL Customer Service Technical AssistanceWhisperKOOL Cooling System Installation Terms and ConditionsProduct Installation Requirements Sales and USE TAX Model Serial NumberA Installed by DatePage Page WhisperKOOL