WhisperKool 5000 owner manual System Operation

Page 32

SYSTEM OPERATION:

Standard and Remote Controls

Initial Start-Up

When power is applied to the unit, the control will briefly display all symbols, and the Compressor sym- bol will be displayed (if unit is calling for cooling). There may be a brief delay prior to the evaporator and condenser fans turning on. When the evaporator and condenser fans are activated the “FAN” symbol will turn on.

Normal System Cycle

After the bottle probe has reached the set point (all units are shipped with the set point of 55°F and a differential of 1°F), the unit will turn off. The Whis- perKOOL Humidity Management (WHM) is an adjust- able feature which allows the customer the conve- nience of managing the humidity enhancement of their wine cellar. The WHM is one of the many Cus- tomer Preference Selection features which allow the customer the ability to fine tune the controls. Feature is off from the factory but can be turned on with the “FON” parameter.

Anti Short Cycle

The Anti Short Cycle ensures that the compressor will remain off for a period of 3 minutes after the unit has reached the set point to allow the pressure in the refrigeration system to equalize prior to starting the compressor.

Anti Frost Cycle

The Anti Frost Cycle is a precautionary measure, as icing or frosting of the coil does not occur during normal operation. The system will go through an anti frost cycle when the evaporator temperature reaches 26°. During the Anti Frost cycle, the unit will stop cooling and run the indoor fan to provide air flow across the indoor coil, which will melt any frost accu- mulation.

Bottle Probe Failure Protection

In the event that a bottle probe should fail, the APST (Advance Product Safety Technology) will automati- cally transition the Refrigeration Compressor cycles to a pre-determined time series (based on detailed laboratory testing), which will ensure that the product is kept within the safe range.

Remote Control (optional)

The control panel can be installed or mounted sepa- rately from the cooling unit itself (remotely), using the supplied cable. This option provides unique flexibility for installing the Extreme Series cooling unit in your wine cellar. The remote option must be specified when the unit is ordered.

Note: Remote Control is generally standard with a “Ducted Unit”.

Ducting and Ventilation Options

The ventilation system is ideal for ducting. The option- al collars fit standard ventilation ducting allowing the installer to vent air to and from the unit for optimum performance (please see specifications for details).

Page 30

EXti 110111

Image 32
Contents Extreme 5000 Page Table of Contents Quick Reference Guide Front / Side ViewFully Ducted Front / Side View 8000 / 8000 Rear / Side View Compressor Access Panel Standard Controller Layout Unit Specifications FAN Speed ReferenceModel Low Med HighIntroduction Review the Packing Slip to Verify Contents Check the Box for the following contents 5000Receiving & Inspecting the Unit Receiving and Inspecting the UnitQuick Start Guide Vapor Barrier Preparing the Wine CellarInsulation Door and Door Seal Mounting the UnitUnobstructed Airflow Air Intake Cellar Wall Ambient Temperature Factor Using any other ducting system will void the warrantyVentilation Exhaust FanElectrical Inlets PRE-INSTALLATIONElectrical Needs Preparing the Installation Location Minimum Tools NeededPreparing the System for Installation Mounting Bracket InstallationSingle Piece Mounting Bracket Applying Insulation Tape8000 Mounting FlangesExterior Grille Installation Non-Flush InstallationFlush Installation Optional Exterior Grille8000 Back of Unit THROUGH-THE-WALL InstallationInstalling the System Ducting Overview Use of DuctworkGeneral Duct Recommendations Location of Supply and Return GrillesDucting Configurations Half Duct Configuration Wine CellarThree-Quarter Duct Configuration Wine Cellar Adjacent RoomFully Ducted Attic Mounted SystemInstalling the Duct Plenums Remote Controller Installation Mounting Bracket Failure to install the drain line voids the warranty Drain LineCondensation Drain Line Tube Drain LineLiquid Measuring Thermostat System Self-Calibrating ProbeLiquid Measuring Thermostat System To Use the thermostat57/57 Multi FAN Speed Control59/59 60/61 System Operation Button/Symbol Normal Functions Standard Controller FunctionsUp and Down ArrowsAlarm Anti-FrostPage Standard Remote Controller Functions Button Normal FunctionsCheck Evaporator Probe connection at green terminal block on Cpsm Mode Remote Wire Schematic Maintenance Schedule Unit does not run/power up Possible Cause Solution Cellar Temperature is to Warm Possible Cause SolutionUnit leaks water Possible Cause Solution Unit runs but does not cool Possible Cause SolutionPossible Cause Solution Compressor short cycles Possible Cause SolutionAccessories for Cooling Units Contact WhisperKOOL Customer ServiceTechnical Assistance Condensate Pump KitInstallation Terms and Conditions WhisperKOOL Cooling SystemProduct Installation Requirements Model Serial NumberA Installed by Date Sales and USE TAXPage Page WhisperKOOL