Smeg LSPX1253 manual Cancelling the Current Program, Changing the Program

Page 13

User instructions

CANCELLING THE CURRENT PROGRAM

To annul the current program, press the START/PAUSE button (4) for a few seconds, until the PROGRAM STARTED light (5) stops flashing. Now press the START/PAUSE button (4) again until "P0" appears on the display (about 10 seconds).

CHANGING THE PROGRAM

To modify the program keep the START/PAUSE button (4) pressed for a few seconds, until the PROGRAM STARTED indicator light (5) stops flashing, then select the new program following the instructions provided above; press the START/PAUSE button (4) again and keep it pressed for a few seconds, until the indicator light (5) starts to flash again.

SELECTING HALF LOAD WASH (on some models only)

This function is ideal for small loads and saves water and electricity. It is controlled by the HALF LOAD (10) button, with two alternatives:

1)press the button once to select washing in the top basket (the relative light comes on);

2)press the button a second time to select washing in the bottom basket (the relative light comes on);

3)press the button a third time to return to the normal full load washing mode (washing in both baskets, both lights off).

12

Image 13

Contents Guide for Using the Dishwasher and the Washing Programs Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models For free-standing models only Installation and hook-upWater supply connection Connecting to the Water SupplyDrain Connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsFuse replacement When Cleaning and Maintaining the ApplianceFor Great Britain only Front panel Description of the controlsBio Setting the Washing ProgramBefore starting a washing program make sure that Washing programsCorrect amount of detergent has been added to the dispenser ProgrammingChanging the Program Cancelling the Current ProgramSelecting Half Load Wash on some models only Press the Program Delay button 6 again the 3-FIGURE Display Delaying the ProgramAvailable in all programs except the soak program To Save on ENERGY! … and Protect the Environment Option ButtonEND Program Starting the DishwasherRemoving the Dishes Operating instructions Using the water softening systemUser instructions Water Hardness Table Using the rinse aid and detergent dispensersAdding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendationsUser instructions Lower Basket Using the basketsLoading the Lower Basket Upper Basket Cutlery BasketLoading the Upper Basket Adjusting the Upper BasketVersion B Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsFill the rinse aid dispenser Shut off the water supply tap Cleaning the Filter UnitReconnect the water intake hose and open the tap again If the dishes are not being cleaned properly, check thatIf the program fails to start, check that If water remains inside the dishwasher, check thatIf there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check thatTroubleshooting Technical Data 135 145