Smeg LSPX1253 manual Troubleshooting

Page 32

User instructions

6. Troubleshooting

The dishwasher is equipped with a self-diagnostics system that is capable of detecting and signalling a number of possible faults.

TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM

 

FAULT

 

DESCRIPTION

 

 

 

 

 

 

E1

 

The anti-flooding system (where present) has been tripped.

 

 

 

 

 

 

E2

 

The water level limitation system has tripped.

 

 

 

 

 

 

E3

 

The appliance cannot heat the water.

 

 

 

 

 

 

E4

 

The temperature sensor is disconnected.

 

 

 

 

 

 

E5

 

The appliance cannot take in the water.

 

 

 

 

 

 

E6

 

The appliance cannot drain the water from the tank.

 

 

 

 

 

 

E7

 

The dishwasher cannot measure the precise water quantity that has

 

 

 

been loaded.

 

 

 

 

 

 

 

 

 

 

E8

 

Problem on the water distribution system to the baskets.

 

 

 

 

 

 

E9

 

Water intake system malfunction.

 

￿The E1, E2, E3, E4, E8, E9 alarms provoke the “forcing” to end cycle of the running program.

￿The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.

￿The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.

To “reset” an alarm is necessary:

￿Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.

If the malfunction persists, contact your authorised Service Centre.

31

Image 32
Contents Guide for Using the Dishwasher and the Washing Programs Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up For free-standing models onlyDrain Connection Connecting to the Water SupplyWater supply connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordFor Great Britain only When Cleaning and Maintaining the ApplianceFuse replacement Description of the controls Front panelSetting the Washing Program BioWashing programs Before starting a washing program make sure thatCorrect amount of detergent has been added to the dispenser ProgrammingSelecting Half Load Wash on some models only Cancelling the Current ProgramChanging the Program Available in all programs except the soak program Delaying the ProgramPress the Program Delay button 6 again the 3-FIGURE Display Option Button To Save on ENERGY! … and Protect the EnvironmentRemoving the Dishes Starting the DishwasherEND Program Using the water softening system Operating instructionsUser instructions Using the rinse aid and detergent dispensers Water Hardness TableAdjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent General warnings and recommendations ProductsUser instructions Loading the Lower Basket Using the basketsLower Basket Cutlery Basket Upper BasketAdjusting the Upper Basket Loading the Upper BasketVersion B Cleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Fill the rinse aid dispenser Shut off the water supply tapIf the dishes are not being cleaned properly, check that Reconnect the water intake hose and open the tap againIf the program fails to start, check that If water remains inside the dishwasher, check thatIf the dishes fail to dry or remain dull, check that If there are visible traces of rust inside the tankTroubleshooting Technical Data 135 145