Smeg LSPX1253 manual Cleaning the Filter Unit

Page 29

User instructions

CLEANING THE FILTER UNIT

ξIt is advisable to periodically inspect the centre filter C and, if necessary, to clean it. To remove the filter, grip the tabs, turn them anticlockwise and lift upwards;

ξpush the centre filter D from the underside to remove it from the micro-filter:

ξseparate the two parts which make up the plastic filter by pressing the body of the filter in the zone shown by the arrows;

ξremove the centre filter by lifting it upwards.

GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE:

ξThe filters should be cleaned under running water using a stiff brush.

ξIt is essential to thoroughly clean the filters according to the above instructions: the dishwasher cannot function if the filters are clogged.

ξCarefully replace the filters in their seats, to avoid damaging the wash pump.

PROLONGED DISUSE:

ξRun the soak program twice in succession.

ξUnplug the power cord from the socket.

ξLeave the door slightly open, in order to prevent the formation of unpleasant odours inside the washing tank.

ξFill the rinse aid dispenser.

ξShut off the water supply tap.

28

Image 29
Contents Guide for Using the Dishwasher and the Washing Programs Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models For free-standing models only Installation and hook-upDrain Connection Connecting to the Water SupplyWater supply connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsFor Great Britain only When Cleaning and Maintaining the ApplianceFuse replacement Front panel Description of the controlsBio Setting the Washing ProgramBefore starting a washing program make sure that Washing programsCorrect amount of detergent has been added to the dispenser ProgrammingSelecting Half Load Wash on some models only Cancelling the Current ProgramChanging the Program Available in all programs except the soak program Delaying the ProgramPress the Program Delay button 6 again the 3-FIGURE Display To Save on ENERGY! … and Protect the Environment Option ButtonRemoving the Dishes Starting the DishwasherEND Program Operating instructions Using the water softening systemUser instructions Water Hardness Table Using the rinse aid and detergent dispensersAdding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendationsUser instructions Loading the Lower Basket Using the basketsLower Basket Upper Basket Cutlery BasketLoading the Upper Basket Adjusting the Upper BasketVersion B Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsFill the rinse aid dispenser Shut off the water supply tap Cleaning the Filter UnitReconnect the water intake hose and open the tap again If the dishes are not being cleaned properly, check thatIf the program fails to start, check that If water remains inside the dishwasher, check thatIf there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check thatTroubleshooting Technical Data 135 145