Smeg LSPX1253 manual Safety instructions, Safety and operating instructions

Page 3

Safety instructions

1. Safety and operating instructions

THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL.

INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USE, AND COMPLIES WITH THE EEC DIRECTIVES 72/23, 89/336 (INCLUDING 92/31) CURRENTLY IN FORCE, INCLUDING THE PREVENTION AND ELIMINATION OF RADIO FREQUENCY INTERFERENCE.

THE APPLIANCE IS DESIGNED FOR THE FOLLOWING PURPOSE: WASHING AND DRYING OF DISHES; ANY OTHER USE SHALL BE CONSIDERED IMPROPER. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR

USES OTHER THAN THOSE DESCRIBED ABOVE.

THE NAME PLATE FEATURING THE TECHNICAL DATA, SERIAL NUMBER AND MARKINGS IS VISIBLY POSITIONED ON THE INNER EDGE OF THE DOOR. THE NAME PLATE ON THE INNER EDGE OF THE DOOR MUST

NEVER BE REMOVED.

DO NOT LEAVE THE DISCARDED PACKAGING MATERIALS UNSUPERVISED WITHIN THE HOME. SEPARATE THE VARIOUS MATERIALS WHICH MAKE UP THE PACKAGING AND TAKE THEM TO THE NEAREST SORTED WASTE COLLECTION CENTRE.

THE APPLIANCE MUST BE PROVIDED WITH AN EARTH CONNECTION IN ACCORDANCE WITH THE ELECTRICAL SAFETY REGULATIONS IN FORCE.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE TO PERSONS OR PROPERTY RESULTING FROM THE FAILURE TO EARTH THE APPLIANCE OR FROM A DEFECTIVE EARTH CONNECTION.

IF THE APPLIANCE IS INSTALLED ON A CARPETED OR COVERED FLOOR, ENSURE THAT THE OPENINGS ON ITS UNDERSIDE ARE NOT OBSTRUCTED.

ALWAYS SWITCH OFF THE DISHWASHER AFTER EACH USE TO AVOID WASTING ELECTRICITY.

2

Image 3
Contents Guide for Using the Dishwasher and the Washing Programs Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models For free-standing models only Installation and hook-upConnecting to the Water Supply Water supply connectionDrain Connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsWhen Cleaning and Maintaining the Appliance Fuse replacementFor Great Britain only Front panel Description of the controlsBio Setting the Washing ProgramProgramming Washing programsBefore starting a washing program make sure that Correct amount of detergent has been added to the dispenserCancelling the Current Program Changing the ProgramSelecting Half Load Wash on some models only Delaying the Program Press the Program Delay button 6 again the 3-FIGURE DisplayAvailable in all programs except the soak program To Save on ENERGY! … and Protect the Environment Option ButtonStarting the Dishwasher END ProgramRemoving the Dishes Operating instructions Using the water softening systemUser instructions Water Hardness Table Using the rinse aid and detergent dispensersAdding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendationsUser instructions Using the baskets Lower BasketLoading the Lower Basket Upper Basket Cutlery BasketLoading the Upper Basket Adjusting the Upper BasketVersion B Avoid the use of acidic or abrasive detergents Cleaning and maintenanceCleaning the Water Intake Filter Cleaning the Spray ArmsFill the rinse aid dispenser Shut off the water supply tap Cleaning the Filter UnitIf water remains inside the dishwasher, check that If the dishes are not being cleaned properly, check thatReconnect the water intake hose and open the tap again If the program fails to start, check thatIf there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check thatTroubleshooting Technical Data 135 145