Smeg LSPX1253 manual Reconnect the water intake hose and open the tap again

Page 30

User instructions

BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:

ξCheck that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes.

ξPlug the power cord back into the socket.

ξReconnect the water intake hose and open the tap again.

TROUBLESHOOTING MINOR PROBLEMS

In some cases it is possible to remedy minor problems by referring to the following instructions:

If the program fails to start, check that:

ξthe dishwasher is connected to the electrical power supply;

ξthere is no power failure;

ξthe water tap is open;

ξthe dishwasher door is properly closed.

If water remains inside the dishwasher, check that:

ξthe drain hose is not kinked;

ξthe drain siphon is not obstructed;

ξthe dishwasher filters are not clogged.

If the dishes are not being cleaned properly, check that:

ξthe correct amount of detergent has been added;

ξthere is regenerating salt inside the special container;

ξthe dishes are being loaded correctly;

ξthe selected program is suitable for the dish types and their degree of soiling;

ξall the filters are clean and positioned correctly;

ξthe spray arm nozzles are not obstructed;

ξthere is no object obstructing the rotation of the spray arms.

29

Image 30

Contents Guide for Using the Dishwasher and the Washing Programs Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up For free-standing models onlyConnecting to the Water Supply Water supply connectionDrain Connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance Fuse replacementFor Great Britain only Description of the controls Front panelSetting the Washing Program BioCorrect amount of detergent has been added to the dispenser Washing programsBefore starting a washing program make sure that ProgrammingCancelling the Current Program Changing the ProgramSelecting Half Load Wash on some models only Delaying the Program Press the Program Delay button 6 again the 3-FIGURE DisplayAvailable in all programs except the soak program Option Button To Save on ENERGY! … and Protect the EnvironmentStarting the Dishwasher END ProgramRemoving the Dishes Using the water softening system Operating instructionsUser instructions Using the rinse aid and detergent dispensers Water Hardness TableAdjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent General warnings and recommendations ProductsUser instructions Using the baskets Lower BasketLoading the Lower Basket Cutlery Basket Upper BasketAdjusting the Upper Basket Loading the Upper BasketVersion B Cleaning the Spray Arms Cleaning and maintenanceCleaning the Water Intake Filter Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Fill the rinse aid dispenser Shut off the water supply tapIf the program fails to start, check that If the dishes are not being cleaned properly, check thatReconnect the water intake hose and open the tap again If water remains inside the dishwasher, check thatIf the dishes fail to dry or remain dull, check that If there are visible traces of rust inside the tankTroubleshooting Technical Data 135 145