Smeg LSPX1253 manual Option Button, To Save on ENERGY! … and Protect the Environment

Page 15

User instructions

"3/1" OPTION BUTTON

(available in all programs except the soak program)

By pressing the button (8) you activate the "3/1" option, confirmed when the relative light comes on. This option has been studied for the use of dishwashing powder or tablets with integrated substances in place of regenerating salt or rinse-aid known on the market as “3 in 1” or “triple action” products; in this case the dishwasher will use the product in an optimal way avoiding salt and rinse-aid consumption, which could already be found in the dishwasher.

Note: When selecting the "3/1" button, it is normal that the salt and rinse-aid lights remain on, if their containers are empty.

TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT

Always try to run the dishwasher fully loaded.

Do not wash the dishes in running water.

Use the washing program that is most appropriate for each type of load.

Do not carry out any preliminary rinsing.

If available, connect the dishwasher to a hot water supply up to 60°C.

TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT

The phosphates contained in dishwasher detergents are harmful to the environment. To avoid using excessive amounts of detergent and to save on electricity, observe the following:

separate the more delicate items from dishes that are more resistant to aggressive detergents and high temperatures;

do not pour the detergent directly on the dishes.

14

Image 15

Contents Guide for Using the Dishwasher and the Washing Programs Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models For free-standing models only Installation and hook-upConnecting to the Water Supply Water supply connectionDrain Connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsWhen Cleaning and Maintaining the Appliance Fuse replacementFor Great Britain only Front panel Description of the controlsBio Setting the Washing ProgramProgramming Washing programsBefore starting a washing program make sure that Correct amount of detergent has been added to the dispenserCancelling the Current Program Changing the ProgramSelecting Half Load Wash on some models only Delaying the Program Press the Program Delay button 6 again the 3-FIGURE DisplayAvailable in all programs except the soak program To Save on ENERGY! … and Protect the Environment Option ButtonStarting the Dishwasher END ProgramRemoving the Dishes Operating instructions Using the water softening systemUser instructions Water Hardness Table Using the rinse aid and detergent dispensersAdding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendationsUser instructions Using the baskets Lower BasketLoading the Lower Basket Upper Basket Cutlery BasketLoading the Upper Basket Adjusting the Upper BasketVersion B Avoid the use of acidic or abrasive detergents Cleaning and maintenanceCleaning the Water Intake Filter Cleaning the Spray ArmsFill the rinse aid dispenser Shut off the water supply tap Cleaning the Filter UnitIf water remains inside the dishwasher, check that If the dishes are not being cleaned properly, check thatReconnect the water intake hose and open the tap again If the program fails to start, check thatIf there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check thatTroubleshooting Technical Data 135 145