Smeg LSPX1253 manual Electrical connection and precautions

Page 8

Installation instructions

2.2 Electrical connection and precautions

CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR.

THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE.

THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION.

NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD.

IN THE EVENT OF DAMAGE TO THE SUPPLY CORD, HAVE IT REPLACED BY THE MANUFACTURER OR AN AUTHORIZED TECHNICAL SERVICE CENTRE.

DO NOT USE ADAPTORS OR SHUNT CONNECTIONS IN ORDER TO AVOID THE POSSIBILITY OF OVERHEATING OR BURNING.

IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD:

IT IS NECESSARY TO INSTALL IN THE FIXED WIRING AN ALL-POLE DISCONNECTION DEVICE HAVING A GAP BETWEEN CONTACTS OF AT LEAST 3.5MM. AFTER INSTALLATION THE DISCONNECTION DEVICE HAS TO BE EASY TO REACH.

THE CONNECTION TO THE MAINS MUST BE CARRIED OUT BY A QUALIFIED TECHNICIAN IN ACCORDANCE TO THE SCHEME SHOWN BELOW AND THE REGULATIONS IN FORCE.

L = brown N = blue

= yellow-green

In the event of damage to the supply cord, have it replaced by the manufacturer or an Authorized Technical Service Centre in order to avoid any risk.

7

Image 8

Contents Guide for Using the Dishwasher and the Washing Programs Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up For free-standing models onlyDrain Connection Connecting to the Water SupplyWater supply connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordFor Great Britain only When Cleaning and Maintaining the ApplianceFuse replacement Description of the controls Front panelSetting the Washing Program BioWashing programs Before starting a washing program make sure thatCorrect amount of detergent has been added to the dispenser ProgrammingSelecting Half Load Wash on some models only Cancelling the Current ProgramChanging the Program Available in all programs except the soak program Delaying the ProgramPress the Program Delay button 6 again the 3-FIGURE Display Option Button To Save on ENERGY! … and Protect the EnvironmentRemoving the Dishes Starting the DishwasherEND Program Using the water softening system Operating instructionsUser instructions Using the rinse aid and detergent dispensers Water Hardness TableAdjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent General warnings and recommendations ProductsUser instructions Loading the Lower Basket Using the basketsLower Basket Cutlery Basket Upper BasketAdjusting the Upper Basket Loading the Upper BasketVersion B Cleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Fill the rinse aid dispenser Shut off the water supply tapIf the dishes are not being cleaned properly, check that Reconnect the water intake hose and open the tap againIf the program fails to start, check that If water remains inside the dishwasher, check thatIf the dishes fail to dry or remain dull, check that If there are visible traces of rust inside the tankTroubleshooting Technical Data 135 145