Smeg LSPX1253 manual User instructions

Page 18

User instructions

ξDo not use table salt as it contains insoluble substances which, over time, may damage the water softening system.

ξWhen necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed by the water; the prolonged presence of salt water inside the tank may lead to corrosion.

Be careful not to confuse the salt and detergent packages; adding detergent to the salt container will damage the water softening system.

ADJUSTING THE WATER SOFTENING SYSTEM (available in all programs except the soak program)

The dishwasher is equipped with an electronic device for adjusting the water softening setting according to the hardness of the water. To adjust the water softening setting, proceed as follows.

Keep the PROGRAM DELAY button (6) pressed for a few seconds, until the H- symbol, followed by the set value, appears on the 3-FIGURE DISPLAY (12).

The PROGRAM DELAY button (6) can be pressed again to select the most suitable hardness value (H1, H2…H5). Refer to the "Water hardness table" to select the value.

To exit the programming mode press the START/PAUSE button (4) or do not touch the keypad for 2 seconds to allow the system to exit the mode automatically.

17

Image 18

Contents Guide for Using the Dishwasher and the Washing Programs Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up For free-standing models onlyConnecting to the Water Supply Water supply connectionDrain Connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance Fuse replacementFor Great Britain only Description of the controls Front panelSetting the Washing Program BioCorrect amount of detergent has been added to the dispenser Washing programsBefore starting a washing program make sure that ProgrammingCancelling the Current Program Changing the ProgramSelecting Half Load Wash on some models only Delaying the Program Press the Program Delay button 6 again the 3-FIGURE DisplayAvailable in all programs except the soak program Option Button To Save on ENERGY! … and Protect the EnvironmentStarting the Dishwasher END ProgramRemoving the Dishes Using the water softening system Operating instructionsUser instructions Using the rinse aid and detergent dispensers Water Hardness TableAdjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent General warnings and recommendations ProductsUser instructions Using the baskets Lower BasketLoading the Lower Basket Cutlery Basket Upper BasketAdjusting the Upper Basket Loading the Upper BasketVersion B Cleaning the Spray Arms Cleaning and maintenanceCleaning the Water Intake Filter Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Fill the rinse aid dispenser Shut off the water supply tapIf the program fails to start, check that If the dishes are not being cleaned properly, check thatReconnect the water intake hose and open the tap again If water remains inside the dishwasher, check thatIf the dishes fail to dry or remain dull, check that If there are visible traces of rust inside the tankTroubleshooting Technical Data 135 145