Smeg LSPX1253 manual When Cleaning and Maintaining the Appliance, For Great Britain only

Page 9

Installation instructions

WHEN CLEANING AND MAINTAINING THE APPLIANCE:

BEFORE CARRYING OUT ANY WORK, ALWAYS UNPLUG THE APPLIANCE FROM THE ELECTRICAL SUPPLY OR SWITCH OFF THE ALL-POLE DISCONNECTION DEVICE.

FOR GREAT BRITAIN ONLY:

THIS APPLIANCE MUST BE EARTHED.

Fuse replacement

If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows:

1.Remove the fuse cover A and fuse B.

2.Fit replacement 13A fuse into fuse cover.

3.Refit both into plug.

The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted.

Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug.

Replacement fuse covers are available from your local electrical store.

8

Image 9

Contents Guide for Using the Dishwasher and the Washing Programs Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models For free-standing models only Installation and hook-upConnecting to the Water Supply Water supply connectionDrain Connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsWhen Cleaning and Maintaining the Appliance Fuse replacementFor Great Britain only Front panel Description of the controlsBio Setting the Washing ProgramBefore starting a washing program make sure that Washing programsCorrect amount of detergent has been added to the dispenser ProgrammingCancelling the Current Program Changing the ProgramSelecting Half Load Wash on some models only Delaying the Program Press the Program Delay button 6 again the 3-FIGURE DisplayAvailable in all programs except the soak program To Save on ENERGY! … and Protect the Environment Option ButtonStarting the Dishwasher END ProgramRemoving the Dishes Operating instructions Using the water softening systemUser instructions Water Hardness Table Using the rinse aid and detergent dispensersAdding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendationsUser instructions Using the baskets Lower BasketLoading the Lower Basket Upper Basket Cutlery BasketLoading the Upper Basket Adjusting the Upper BasketVersion B Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsFill the rinse aid dispenser Shut off the water supply tap Cleaning the Filter UnitReconnect the water intake hose and open the tap again If the dishes are not being cleaned properly, check thatIf the program fails to start, check that If water remains inside the dishwasher, check thatIf there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check thatTroubleshooting Technical Data 135 145