Smeg LSPX1253 manual Aquastop Models

Page 5

Safety instructions

LEANING OR SITTING ON THE DISHWASHER DOOR WHEN OPEN MAY CAUSE THE APPLIANCE TO OVERTURN, PUTING PEOPLE AT RISK. NEVER LEAVE THE DISHWASHER DOOR OPEN; PEOPLE MIGHT TRIP OVER IT.

DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE.

KNIVES OR OTHER SHARP-ENDED COOKING UTENSILS MUST BE PLACED IN THE CUTLERY BASKET BLADE-DOWN, OR LAID HORIZONTAL IN THE TOP BASKET. TAKE CARE NOT TO CUT YOURSELF AND ENSURE THAT THEY DO NOT PROJECT FROM THE BASKET.

AQUASTOP MODELS

THE AQUASTOP DEVICE PREVENTS FLOODING IN THE EVENT OF A WATER LEAK. WHEN THE AQUASTOP DEVICE IS TRIPPED, CALL IN A QUALIFIED TECHNICIAN TO IDENTIFY AND REPAIR THE FAULT.

IN MODELS EQUIPPED WITH THE AQUSTOP DEVICE, THERE IS A SOLENOID VALVE INSIDE THE WATER INTAKE HOSE. DO NOT CUT THE

HOSE AND DO NOT ALLOW THE SOLENOID VALVE TO DROP INTO WATER. IN THE EVENT OF DAMAGE TO THE WATER INTAKE HOSE, DISCONNECT THE APPLIANCE FROM THE ELECTRICAL POWER SUPPLY AND FROM THE WATER SUPPLY.

IMMEDIATELY AFTER INSTALLING THE DISHWASHER, PERFORM A QUICK TEST OF THE APPLIANCE FOLLOWING THE INSTRUCTIONS BELOW. IF THE DISHWASHER FAILS TO OPERATE CORRECTLY, DISCONNECT IT FROM THE ELECTRICAL POWER SUPPLY AND CALL THE NEAREST TECHNICAL SERVICE CENTRE. DO NOT ATTEMPT TO REPAIR THE

APPLIANCE.

THE DISHWASHER MEETS ALL THE REQUIREMENTS SET OUT BY THE REGULATIONS IN FORCE CONCERNING SAFETY AND ELECTRICAL EQUIPMENT. ANY TECHNICAL CHECKS SHOULD BE CONDUCTED EXCLUSIVELY BY A TRAINED AND AUTHORISED TECHNICIAN: REPAIRS

CARRIED OUT BY UNAUTHORISED PERSONS WILL INVALIDATE THE WARRANTY, AS WELL AS POSING A POTENTIAL HAZARD TO THE USER.

The manufacturer declines all responsibility for damage to persons or property resulting from failure to observe the above precautions, from tampering with even a single component of the appliance, or from the use of non original spare parts.

4

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Guide for Using the Dishwasher and the Washing Programs Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models For free-standing models only Installation and hook-upDrain Connection Connecting to the Water SupplyWater supply connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsFor Great Britain only When Cleaning and Maintaining the ApplianceFuse replacement Front panel Description of the controlsBio Setting the Washing ProgramBefore starting a washing program make sure that Washing programsCorrect amount of detergent has been added to the dispenser ProgrammingSelecting Half Load Wash on some models only Cancelling the Current ProgramChanging the Program Available in all programs except the soak program Delaying the ProgramPress the Program Delay button 6 again the 3-FIGURE Display To Save on ENERGY! … and Protect the Environment Option ButtonRemoving the Dishes Starting the DishwasherEND Program Operating instructions Using the water softening systemUser instructions Water Hardness Table Using the rinse aid and detergent dispensersAdding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendationsUser instructions Loading the Lower Basket Using the basketsLower Basket Upper Basket Cutlery BasketLoading the Upper Basket Adjusting the Upper BasketVersion B Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsFill the rinse aid dispenser Shut off the water supply tap Cleaning the Filter UnitReconnect the water intake hose and open the tap again If the dishes are not being cleaned properly, check thatIf the program fails to start, check that If water remains inside the dishwasher, check thatIf there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check thatTroubleshooting Technical Data 135 145
Top Page Image Contents