PROGRAMMER / CLOCK
To set the time of day | Setting the minute minder |
◆Press the Up and Down buttons together for a few seconds, and release.
◆The ‘●’ in between the numbers on the LED Display will begin to flash.
◆While the ‘●’ is flashing it is possi- ble to adjust the time using the Up and Down buttons. Once the time has been set, allow approximately 30 sec- onds before using any of the other timer functions. This ensures that the time will remain correct.
To select an alarm tone
There are three tones to chose from.
◆Press and hold the down button to lis- ten to the first tone.
◆Release the down button and press it again to listen to the second tone etc.
◆Releasing the down button after the tone has sounded will automatically select that tone
◆To set the Minute Minder, press the Function button once. The bell symbol will appear and start flashing. The flashing only lasts for 5 seconds so the time must be set within this time frame.
◆Use the Up and Down button to set the length of time required. Once this has been done, the Minute Minder is set.
◆When the desired length of time has counted down the alarm will sound.
◆To cancel the tone, press any of the buttons.
◆To cancel the Minute Minder at any time, press the Up and Down buttons together.
36