Danby DKC146SLDB manual Spanner Faucet Wrench, Plastic Faucet Lever Dispensing Of Beer

Beer Keg Installation Instructions

SPANNER FAUCET WRENCH

Spanner faucet wrench is provided for either removing or tightening connection.

PLASTIC FAUCET LEVER

DISPENSING OF BEER

Attach the black plastic lever (pull handle) to the top of the faucet by tightening it by hand clockwise until the end, holding in the silver nut underneath so it does not turn. If there is still a small drip from the faucet, you may have tightened the plastic lever too much and may need to unscrew silver snug counter-clockwise (as shown) one turn.

•Keep beer keg refrigerated at all times.

•Never allow beer lines to dry out.

•Use clean beer glassware before pouring.

•Hold glass at a 45° angle when 2/3 full, start to straighten glass as the glass fills.

•Always make sure the faucet handle is pushed all the way back.

Note: Keg sizes that can be used in your beer dispenser

1/2 barrel	59 Liters	15.5 gals	1984 oz.	164/12-oz. Glass
1/4 barrel	30 Liters	7.8 gals.	992 oz.	82/12-oz. Glass
1/6 barrel	20 Liters	5.2 gals.	661 oz.	55/ 12-oz. Glass
1/8 barrel	15 Liters	4.0 gals.	496 oz.	41/ 12-oz. Glass

Note: Our Beer dispenser accepts standard kegs up to 16-1/8” in diameter, and up to 23-3/8” in height. Check with your distributor to make sure keg is correct size.

11