Operating Instructions
AUTOMATIC
DEFROSTING
CONVERTING TO AN “ALL REFRIGERATOR”
There is no need to defrost the Beer Dispenser. Defrost water collects and passes thru the drain outlet in the rear wall into a tray located above the compressor, where it evaporates.
NOTE: If the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the Beer Dispenser may not start.
1.Turn off the control knob to the “OFF” position.
2.Close the main valve on the CO2 cylinder.
3.Close the secondary
4.Close the connection between the beer keg and the keg coupler.
5.Drain any remaining beer from the lines.
6.Disconnect the beer line and CO2 air line from the keg coupler
7.Remove the beer keg.
8.Remove the keg coupler.
9.Disconnect the air line from the CO2 cylinder.
10.Remove the CO2 air line from cabinet plug
11.Replace the air line rear cabinet plug
12.Remove the beer tower. Also pull the beer line thru the top of the cabinet
13.Replace the top cabinet plug
14.Adjust temperature as desired.
12