UnpacktheWine Cellar
WARNING
Excessive Weight Hazard
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces before turning on the wine cellar. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your wine cellar.
For more information, see “Wine Cellar Safety.” Dispose of/recycle all packaging materials.
When Moving Your Wine Cellar:
Your wine cellar is heavy. When moving the appliance
for cleaning and service, be sure to protect the floor. Always pull the appliance straight out when moving it. Do not wiggle or “walk” the appliance when trying to move it, as floor damage could occur.
Clean Before Using
After you remove all of the packaging materials, clean the inside of your wine cellar before using it. See the cleaning instructions in “Wine Cellar Care.”
Wine CellarDoor
IMPORTANT: All graphics referenced in the following instructions are included later in this section after “Final Steps.” The graphics shown are for a
Remove Door and Hinge
1.Unplug wine cellar or disconnect power.
WARNING
Excessive Weight Hazard
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
2.Place the wine cellar on its back.
3.Remove the bottom right leveling leg. See Graphic 4.
4.Remove the the screws from the lower hinge assembly. See Graphic 3.
5.Pull the door downward to remove it from the cabinet of the wine cellar.
4