Blodgett MT3855G-G manual GAS Hose Restraint, See View a

Page 17

Installation

Gas Connection

GAS HOSE RESTRAINT

If the oven is mounted on casters, a commercial flexible connector with a minimum of 3/4” (1.9 cm) inside diameter must be used along with a quick connect device.

The restraint, supplied with the oven, must be used to limit the movement of the unit so that no strain is placed upon the flexible connector. The restraint should be fastened to the base frame of the oven as close to the flexible connector as pos- sible. It should be short enough to prevent any strain on the connector. With the restraint fully stretched the connector should be easy to install and quick connect.

The restraint (ie: heavy gauge cable) should be at- tached without damaging the building. DO NOT use the gas piping or electrical conduit for the at- tachment of the permanent end of the restraint! Use anchor bolts in concrete or cement block. On wooden walls, drive hi test wood lag screws into the studs of the wall.

WARNING!!

If the restraint is disconnected for any reason it must be reconnected when the oven is returned to its original position.

U.S. and Canadian installations

The connector must comply with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors For Moveable Gas Ap- pliances CAN/CGA-6.16and a quick disconnect device that complies with the Standard for Quick- Disconnect Devices for Use With Gas Fuel, ANSI Z21.41 or Quick Disconnect For Use With Gas Fuel CAN 1-6.9. Adequate means must be provided to

limit the movement of the appliance without de- pending on the connection and the quick discon- nect device or its associated piping.

A drip leg must be used at each appliance. Refer to NFPA54/ANSI Z223.1 - Latest Edition (National Fuel Gas Code) for proper drip leg installation.

Australia and general export installations

The restraint and quick connect must conform with Local and National installation standards. Lo- cal installation codes and/or requirements may vary. If you have any questions regarding the prop- er installation and/or operation of your Blodgett oven, please contact your local distributor. If you do not have a local distributor, please call the Blodgett Oven Company at 0011-802-860-3700.

Attachment Plate

Gas

Supply Line

(secure with leg

 

mount bolt)

Socket

 

 

Gas

 

Hose

(See VIEW A)

Socket

Plug

Quick Connect

Attachment Plate

(2 supplied)

1 for wall mount

1 for leg bolt

Note: fastener for wall mount not supplied

IMPORTANT:

Cable restraint should be fas- tened as close as possible to flex- ible connector and short enough to prevent any strain on flexible connect. At maximum stretch of shortened restraint the flexible connector should be easy to in- stall and quick connect.

VIEW A

Tighten after adjustment

Installation of Gas Hose and Restraint

Figure 14

13

Image 17
Contents MT3855G-G Avertissement Reputation YOU can Count on Page Table of Contents/Table des Matières Specifications Oven Description and SpecificationsCanadian installations Australia and General Export installationsOven Components Emergency Shut Down Switch --- allows user toNozzle Hold-Down Bracket --- holds the front end Air Flow Plates 2, drive and idle sides --- disPart Description Qty Delivery and InspectionVentilation Oven Location and VentilationLocation Oven Supports and Casters Oven AssemblyReturn AIR Diverters Nozzles Folding Conveyor Remote Computer Control END PlugsCrumb Pans Utility Connections --- Standards and Codes GAS Piping Gas ConnectionExample Pipe Nominal Size, Inches LengthPressure Regulation and Testing See View a GAS Hose RestraintElectrical Connection Safety Tips Safety InformationWhat to do in the event of a power failure General safety tipsCooking Computer Programming the TemperatureControl Description ProgrammingDisplay Information OperationConveyor Speed and Oven Temperature Oven Adjustments for CookingFinished Product Temperatures AIR Flow AdjustmentsDaily CleaningEvery Three Months Every Six MonthsMaintenance Every 12 Months Control Box Component Locations Possible Causes Suggested Remedy Troubleshooting GuideTroubleshooting Guide MT3855G-G Spécifications Description et Spécifications du FourEnsemble de la bande transporteuse repliable Éléments du FourDescription des Pièces Qté Livraison et InspectionImplantation DU Four Implantation et aération du fourAération DU Four AvertissementLES Supports DU Four ET LES Roulettes Montage du FourDéviateurs d’air --- Vue du dessous Déviateurs DE L’AIR EN Retour LES BusesBande Transporteuse Repliable ’ORDINATEUR DE Cuisson Détaché LES ArrêtoirPlateaux Pour Miettes Branchements de Service --- Normes et Codes Conduit DE GAZ Branchement de GazExemple Longeur de Diamètre extérieur Conduit piedsRéglage ET Test DE Pression Retenue DU Tuyau DE GAZ Raccordement Électrique Conseils DE Sécurité Informations de SécuritéQue faire en cas de panne de secteur ’arret d’urgence automatiquePour programmer la temperature Identification DES Commandes’Ordinateur de Cuisson LA Procédé ProgrammerAutres Messages DE L’AFFICHEUR UtilisationVitesse DU Convoyeur ET Température DU Four Ajustements du Four Pour la CuissonTempérature DES Aliments Cuits Ajustement DE LA Circulation D’AIRUtilisation Quotidiennement NettoyageTous les trois mois Tous les six moisEntretien Tous les 12 mois Emplacements des Composants du Boîtier de Commande Causes Probables Suggestion Guide de Détection des PannesGuide de Détection des Pannes Entretien Insert Wiring Diagram Here Placer Schéma DE Câblage ICI

MT3855G-G specifications

The Blodgett MT3855G-G is a state-of-the-art combination oven that stands out in the world of commercial cooking equipment. Designed for versatility and efficiency, this unit serves as a powerful tool for chefs aiming to create high-quality dishes while maximizing kitchen space.

One of the main features of the MT3855G-G is its innovative combination cooking mode that allows users to operate the oven in either convection or steam mode, or even a combination of both. This flexibility provides the ability to cook a wide range of items, from delicate pastries to hearty meats, ensuring optimal results for each dish. The oven's ability to switch seamlessly between modes allows for greater control over cooking processes, resulting in evenly cooked, flavorful meals.

The MT3855G-G is equipped with a user-friendly digital control panel that simplifies operation. This interface allows chefs to easily set time and temperature, select cooking modes, and monitor progress. The programmable cooking options enable users to store up to 100 recipes, ensuring consistency and efficiency in busy kitchen environments. The intuitive design ensures that both experienced cooks and novices can utilize its features effectively.

Energy efficiency is another key characteristic of the Blodgett MT3855G-G. The oven utilizes a high-efficiency steam generator that reduces water consumption while still delivering exceptional steam quality. This feature not only aids in energy conservation but also contributes to a lower operational cost, making it an economically viable choice for commercial kitchens.

In terms of construction, the MT3855G-G boasts a durable stainless steel exterior, ensuring longevity and easy maintenance. The oven's interior is designed to withstand high temperatures and heavy use, featuring a fully welded, easy-to-clean design that minimizes buildup and simplifies sanitation procedures. The double-pane glass door provides excellent insulation while allowing for visibility during the cooking process.

Additionally, the Blodgett MT3855G-G is designed with safety features, including a cool-touch exterior that minimizes the risk of burns and a low water indicator that ensures safe operation. This attention to safety makes it suitable for high-volume environments, allowing staff to work efficiently without compromising their well-being.

In conclusion, the Blodgett MT3855G-G combination oven is a versatile, efficient, and durable piece of equipment designed to meet the demands of modern commercial kitchens. With its advanced cooking technologies, user-friendly controls, and maintenance-friendly design, it is an invaluable asset for any culinary professional striving for excellence in food preparation.