Hearth and Home Technologies 6000BE owner manual Flue Restrictor Instructions, Vertical Venting

Page 15

CAP

STRAIGHT UP

VERTICAL VENTING

V (FT.)

40' MAX. (12.4 M)

NOTE: On vertical venting configurations over 10 feet install the flue restrictor (385-128). See flue restric- tor installation instructions.

Figure 6.

Straight Up Vertical Venting

Flue Restrictor Instructions

1.Remove Exhaust Shield using a 1/4” nut driver by removing the four screws securing it in place (see Figure 7).

EXHAUST

SHIELD

FLUE

RESTRICTOR

Figure 7

2.Break the Flue Restrictor into two pieces. Do this by bending the part back and forth until it breaks (see Figure 8).

BREAK

HERE

Figure 8. Flue Restrictor

Hearth & Home Technologies • 6000BE, 6000BE-IPI • 2024-900 Rev. G • 11/05

Image 15

Contents What to do if you smell gas Installation and OperationSafety and Warning Information Table of Contents Log Set Assembly Service PartsGLA-750TR Service Parts List 6000BE, 6000BE-IPIIntermittent Pilot Ignition Valve AssemblyStanding Pilot Ignition 6000BECertification High Altitude InstallationsInstallation Codes Appliance CertificationPre-install Preparation Introducing the Hearth & Home Technologies Gas FireplacesANY Such Action MAY Possibly Cause a Fire Hazard GAS Line Access Diagram of the 6000BE, 6000BE-IPIConstructing the Fireplace Chase Locating the FireplaceClearance Requirements Framing the Fireplace Framing DimensionsDVP90ST Identifying Vent Components Installing the Vent SystemVent System Approvals Tems or Components MAY be UsedFlue Restrictor Instructions Vertical VentingMAX .4 M Straight Up Vertical Venting Chart Venting with One 90 Elbow Venting with ONE 1 90 ElbowVenting with Two 90 Elbows Venting with TWO 2 90 o ElbowsVenting with three 90 elbows Venting with Three 3 90 Elbows+ V 1 FT + H 1 FT Installing Vent Components Above the First 900 Elbow in the Venting System To Install the Heat ShieldInstall Support Brackets Continue Adding Vent Components12 Hole and Vent Pipe Vent Termination Attic FirestopHorizontal Termination Alcove Applications ServiceProper Positioning Leveling and Securing of a Fireplace Positioning, Leveling, and Securing the FireplaceIntermittent Pilot Ignition IPI System Installing the Optional Heat-Zone Kit Gas Control SystemsVice Must be Wired Directly to the FIRE- Place Junction BOX Standing Pilot Ignition SystemCheck for GAS Leaks Gas Supply LineGas Pressure Requirements Pressure Natural Gas PropaneWall Switch Wiring the FireplaceFor Standing Pilot Ignition Wiring Appliance Requirements Optional AccessoriesBRN Operation using Battery PowerInstalling Trim, Logs, and Ember Material Installing the TrimFinishing Positioning the Logs Follow these stepsCover Ports Shutter SettingsGlass Assembly Placing the Ember Material6000BE Tempered 6000BE-IPI Tempered Double-check for faulty components Cold Climate SwitchBefore Lighting the Fireplace Important Turn OFF the GAS Before Servicing Your Fireplace After the InstallationFireplace Maintenance Lighting the Fireplace